WASHER/DRYER MAINTENANCE
WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.
WASHER CARE
Recommendations to Help Keep Your Washer Clean and Performing at its Best
1.Always follow the detergent manufacturer’s instructions regarding the amount of detergent to use. Never use more than the recommended amount because that may increase the rate at which detergent and soil residue accumulate inside your washer, which in turn may result in undesirable odor.
2.Use warm and hot wash water settings sometimes (not exclusively cold water washes), because they do a better job of controlling the rate at which soils and detergent accumulate.
3.Always leave the washer lid open between uses to help dry out the washer and prevent the buildup of
Cleaning Your Top Loading Washer
Read these instructions completely before beginning the routine cleaning processes recommended below. This Washer Maintenance Procedure should be performed, at a minimum, once per month or every 30 wash cycles, whichever occurs sooner, to control the rate at which soils and detergent
may otherwise accumulate in your washer. To keep washer interior
affresh® Washer Cleaner Cycle Procedure (Recommended for Best Performance):
a.Open the washer lid and remove any clothing or items.
b.Place an affesh® Washer Cleaner tablet in the bottom of the washer basket.
c.Do not add any detergent or other chemical to the washer when following this procedure.
d.Close the washer lid.
e.Select Normal Heavy cycle, Hot Temperature, and Large Load Size.
f.Pull out the Cycle knob. Water will pour into washer for a moment and then pause; the lid will lock and the cycle will continue.
NOTE: For best results, do not interrupt cycle. If cycle must be interrupted, push in the Cycle knob.
WASHER CARE (cont.)
Chlorine Bleach Procedure (Alternative):
a.Open the washer lid and remove any clothing or items.
b. Add 1 cup (236 mL) of liquid chlorine bleach to the bleach compartment.
NOTE: Use of more liquid chlorine bleach than is recommended above could cause washer damage over time.
c.Do not add any detergent or other chemical to the washer when following this procedure.
d.Close the washer lid.
e.Select Normal Heavy cycle, Hot Temperature, and Large Load Size.
f.Pull out the Cycle knob. Water will pour into washer for a moment and then pause; the lid will lock and the cycle will continue.
NOTE: For best results, do not interrupt cycle. If cycle must be interrupted, push in the Cycle knob.
Cleaning the liquid fabric softener dispenser
1.Remove dispenser by grasping top with both hands and squeezing, while pushing upward with thumbs.
2.Rinse dispenser under warm water, then replace it.
NOTE: To avoid damage to the washer or clothing, do not wash clothes with the liquid fabric softener dispenser removed.
Cleaning the bleach dispenser
Wipe the inside of the bleach dispenser with a clean, damp cloth.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe away any spills. Use only mild soaps or cleaners when cleaning external washer surfaces.
IMPORTANT: To avoid damaging the washer’s finish, do not use abrasive products.
14