Changing the Drum Light on some models | Whirlpool W10376238C

CHANGING THE DRUM LIGHT (on some models)

1.Unplug dryer or disconnect power.

2.Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Using a Phillips-head screwdriver, remove the screw located in the lower right-hand corner of the cover. Remove the cover.

3.Turn bulb counterclockwise. Replace the bulb with

a 10-watt appliance bulb only. Replace the cover and secure with the screw.

4.Plug into a grounded outlet or reconnect power.

VACATION, STORAGE, AND MOVING CARE

Non-Use or Storage Care

Operate your washer/dryer only when you are at home. If you will be on vacation or not using your washer/dryer for an extended period of time, you should:

1.Unplug washer/dryer or disconnect power.

2.Turn off water supply to washer, to avoid flooding due to water pressure surge.

3.For gas dryers only: Close shut-off valve to gas supply line.

4.Clean lint screen. See “Cleaning the Lint Screen.”

Moving Care

For power supply cord-connected washer/dryers:

1.Unplug the power supply cord.

2.Make sure leveling legs are secure in washer/dryer base.

3.Continue with “For washer” below.

VACATION, STORAGE, AND MOVING CARE (cont.)

For direct-wired washer/dryers:

1.Turn off power at fuse or breaker box.

2.Disconnect wiring.

3.Make sure leveling legs are secure in washer/dryer base.

4.Continue with “For washer” below.

For gas washer/dryers:

1.Unplug or disconnect power to washer/dryer.

2.Close shut-off valve in gas supply line.

3.Disconnect gas supply line pipe and remove fittings attached to dryer pipe.

4.Cap the open fuel supply line.

5.Make sure leveling legs are secure in washer/dryer base.

6.Continue with “For washer” below.

For washers:

1.Shut off both water faucets. Disconnect and drain water inlet hoses.

2.If washer/dryer will be moved during freezing weather, follow “Winter Storage Care” directions before moving.

3.Disconnect drain from drain system and drain any remaining water into a pan or bucket. Disconnect drain hose from back of washer.

4.Place inlet hoses and drain hose inside washer basket.

5.Drape power cord over edge and into washer basket.

6.Place packing tray from original shipping materials back inside washer/dryer. If you do not have packing tray, place heavy blankets or towels into basket opening. Close doors and place tape over doors and down front of washer/dryer. Keep doors taped until washer/dryer is placed in new location.