4. Select End of Cycle signal (optional)
Your dryer may have an End of Cycle signal. The signal is helpful when drying items that should be removed from the dryer as soon as it stops. The End of Cycle signal is part of the PUSH TO START button and is selectable. Turn the PUSH TO START button to ON or OFF. The signal will sound only if the selector is set to ON.
NOTE: When the Tumble Press® setting is selected and the End of Cycle signal is on, the tone will sound every 5 minutes until the clothes are removed or the Tumble Press® setting ends.
5. Press PUSH TO START to begin cycle
Push and hold the PUSH TO START knob to begin the cycle.
Promptly remove garments after cycle has completed to reduce wrinkling. Use the Tumble Press® feature to avoid wrinkling when you are unable to remove a load from the dryer as soon as it stops.
ADDITIONAL FEATURES
USING THE DRYING RACK
To obtain a drying rack for your dryer, follow the instructions included in your dryer drum. Remove and discard any packing material before use.
Use the drying rack for items that you do not want to tumble dry, such as sweaters and tennis shoes. When you use the drying rack, the drum continues to turn, but the rack remains stationary.
The drying rack is intended for use with the Manual Dry/ Timed Drying cycles only. The drying rack cannot be used with Automatic cycles.
To use the drying rack:
IMPORTANT: Do not remove the lint screen.
1.Open dryer door.
2.Align the two hooks on the front of the drying rack with the holes in the dryer door opening and press down fully into holes. Rest the rear support on the dryer back ledge.
3.Place wet items on top of the drying rack. Allow space around items for air to circulate. The drying rack does not move, but the drum will rotate. Make sure items do not hang over the edges or between drying rack grille.
4.Close the door.
5.Select a Timed Drying/Fluff Air, or Low Temperature cycle. Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Fluff Air setting.
6.When the cycle is selected, the Estimated Time Remaining display shows the default time. You can change the actual time in the cycle by increasing or decreasing the cycle time.
7.Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated from items dried on the drying rack after the cycle is finished.
13