Kenmore 110.8587#, 110.8586# Style 2 Direct wire strain relief, Wire connection Power supply cord

Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point.

Style 2: Direct wire strain relief

Unscrew the removable conduit connector and any screws from a %" (1.9 cm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads.

A

B

A. Removable conduit connector

B. Hole below terminal block opening

C. Strain relief threads

Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable.

4.Now complete installation following instructions for your type of electrical connection:

4-wire (recommended)

3-wire (if 4-wire is not available)

Electrical Connection		Options
If your home has:		And you will be		Go to Section
		connecting	to:
4-wire	receptacle	A UL listed,		4-wire	connection:
(NEMA Type 14-30R)		120/240-volt		Power	supply cord
		30-amp, dryer
	_	power supply
		minimum,
		cord*
4-wire	direct	A fused		4-wire	connection:
		disconnect	or	Direct Wire
		circuit breaker
		box*
	(12J cm)
3-wire	receptacle	A UL listed,		3-wire	connection:
(NEMA type 10-30R)		120/240-volt		Power	supply cord
		30-amp, dryer
	_)	power supply
		minimum,
		cord*
3-wire	direct	A fused		3-wire	connection:
		disconnect	or	Direct Wire
		circuit breaker
		box*

*If local codes do not permit the connection of a frame- grounding conductor to the neutral wire, go to "Optional 3-wire connection" section.

4-wire connection: Power supply cord

IMPORTANT: A 4-wire connection is required for mobile homes

and where local codes do not permit the use of 3-wire connections.

BF

CG

A. 4-wire receptacle (NEMA type 14-30R)

B. 4-prong plug

C. Ground prong

D. Neutral prong

E. Spade terminals with upturned ends

F. 3_,, (1.9 cm) UL listed strain relief

G. Ring terminals

10