Fire Hazard
Use a heavy metam vent.
De net use a pBaetic vent,
De net use a metam foil vent,
Failure to fellow these instructions can result in death or fire,
WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS.
IMPORTANT: Observe all governing codes and ordinances,
The dryer exhaust must not be connected into any gas vent, chimney, wall, ceiling, or a concealed space of a building,
If using an existing vent system
•Clean lint from the entire length of the system and make sure exhaust hood is not plugged with lint.
•Replace any plastic or metal foil vent with rigid or flexible heavy metal vent.
•Review Vent system chart. Modify existing vent system if necessary to achieve the best drying performance.
If this is a new vent system
Vent material
•Use a heavy metal vent. Do not use plastic or metal foil vent.
•4" (10.2 cm) heavy metal exhaust vent and clamps must be used. DURASAFE TM venting products are recommended.
4" (!0.2 cm) heavymetal exhaust vent
DURASAFE TM vent products can be purchased from your dealer. For further information, please call
Rigid metal vent
•For best drying performance, rigid metal vents are recommended.
•Rigid metal vent is recommended to avoid crushing and kinking.
Flexible metal vent
•Flexible metal vents are acceptable only if accessible for cleaning.
•Flexible metal vent must be fully extended and supported when the dryer is in its final position.
•Remove excess flexible metal vent to avoid sagging and kinking that may result in reduced airflow and poor performance.
•Do not install flexible metal vent in enclosed walls, ceilings or floors.
Elbows
45 ° elbows provide better airflow than 90 ° elbows.
GoodBetter
Clamps
•Use clamps to seal all joints.
•Exhaust vent must not be connected or secured with screws or other fastening devices that extend into the interior of the duct. Do not use duct tape.
!Oc
Clamp
Exhaust
Recommended hood styles are shown here.
B
(10.2cm)
A. Louvered hood style
B. Box hood style
14