Bosch Appliances WTXD5321CN Installation X step by step, Transport, Preparing, Dryer Step By step

Check list before using the dryer

1. Check that steps 1-12 have been implemented properly.

2. Ensure that the dryer is connected to the power supply.

3. Read the operating instructions to understand how your dryer operates.

4. Conduct an appliance test:

q Check that the drum is empty. q Close the dryer door.

q Switch the dryer to "extra dry" and then press the Start button.

q After 3-5 minutes press the Stop button and open the door.

5. If the interior of the dryer feels warm, the dryer has been connected properly.

Switch the dryer to "off".

Dryer rack 10. Position and then level the .dryer

part no.WZ20390

Use the dryer rack to dry washable woolen textiles (e.g. sweaters) and shoes.

Left hinge kit

part no.WZ20360

The door catch can be reversed if necessary. The door is hinged on the right at the factory.

Pedestal Mounting

If mounting the dryer on the Siemens pedestal (accessory no.

WZ 20395) follow the instructions supplied with the pedestal.

Installation X step by step

1.Unpack the dryer.

2.Remove all objects from the drum.

3.Check the dryer for visible damage.

4.Position the dryer near the installation location.

5.If required, change the door hinges to the left (see page 6).

6.If required, have customer service install the exhaust air outlet on the dryer (see page 7).

7.Have the power supply cord fitted by an authorized technician (see page 6).

8.Install exhaust duct if necessary. Follow the installation instructions supplied by the appropriate manufacturer!

iIf space is very restricted, it is

recommended to fit the initial	parts
of the exhaust duct to the dryer
before the dryer is moved to	its
final installation location.

9.Move the dryer to its final location and align.

6.

If the

dryer does not work, switch

the

dryer

to

"off".

Look in

the

troubleshooting

The

dryer should be

level

with all

section

(page

40) of

the

four feet firmly on the ground. The

OPERATING

INSTRUCTIONS

and

dryer

must

not

wobble. If the

dryer

find

the

fault.

is not level

or

if it

does

wobble,

the

to

transport

the

feet must be adjusted. Adjust the

Preparing

heightoadjustable

feet

until

the

dryer

X

step

by step

dryer

does

not

rock

and

is

level,

1.

Rotate

the program

selector

both

frontotooback and

to "off".

sideotooside.

2.

Pull

out

the

power

supply

plug.

11. Connect

the exhaust

duct

to

the

3.

Disconnect the

exhaust duct from

exhaust

air

outlet on

the

dryer.

the

exhaust

air outlet on the dryer.

12. Insert

plug

into

the

wall receptacle. 4. Place

any accessories in the drum.

5.

Close

the door and secure with

adhesive

tape.

6.

Screw

the heightoadjustable

feet of

the dryer into the housing to

prevent them from being damaged

during

transportation.

CAUTION

Do not slide dryer across the floor if heightoadjustable feet have been extended. Feet and/or dryer base may be damaged if dryer is slid across floor with heightoadjustable feet extended.

9