A combination of pipe fittings must be used to connect the dryer to the existing gas line. Shown is a recommended connection. Your connection may be different, according to the supply line type, size and location.
4.Lay the dryer door on a flat, protected surface with the inside door assembly facing up.
Remove the 5 screws to release the outer door assembly from the inner door assembly, as indicated below. See illustration. It is important that you remove only the
5 indicated screws.
A
B
D
C
A. ³⁄₈" flexible gas connector
B. ³⁄₈" dryer pipe
C. ³⁄₈" to ³⁄₈" pipe elbow
D.³⁄₈"
3.Open the shutoff valve in the supply line. The valve is open when the handle is parallel to the gas pipe.
A
B
A. Closed valve
B. Open valve
4.Test all connections by brushing on an approved noncorrosive
Reverse Door Swing
You can change your door swing from a
NOTE: For ease of installation, you may want to use 2 or more people to remove and reattach the dryer door.
Remove the door
1.Place a towel or soft cloth on top of the dryer or work space to protect the surface.
2.Open the dryer door. Remove the 5 screws that hold the door hinge on the front panel of the dryer.
A 
C 
B
A. Dryer front panel
B. Dryer door
C. Screws
3.Remove the door.
5.Lift the inner door assembly off of the outer door assembly. Set the outer door assembly aside.
Reverse the hinge
1.Place the inner door, screw head side up, on the work space.
2.Remove the 4 hinge screws that hold the hinge to the door and remove hinge.
AB
C
C
A
B
A.Hinge side screw
B.Locator pins on hinge
C.Top side screw
3.Move the large hole screw to the opposite side. Remove the 2 plug screws and plastic plugs, and insert them in the original screw holes on the opposite side.
A 
B
C
A. Hinge screws
B. Large hole screw
C. Plug screws and plastic plugs
4.Move hinge to the other side and reattach with the 4 screws removed in Step 2. Make sure locator pins line up in holes and drive the top 2 screws in place first to help drive locator pins into proper location.
5.Set the inner door assembly aside.
13