WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
■Is the dryer located in a room with temperature below 45ºF (7ºC)?
Proper operation of dryer cycles requires temperatures above 45ºF (7ºC).
■Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and bottom of the door. For most installations, the rear of the dryer requires 5" (12.7 cm). See the Installation Instructions.
■Has an air dry modifier been selected?
Select the right temperature for the types of garments being dried. See “Modifiers.”
■Is the load too large and heavy to dry quickly? Separate the load to tumble freely.
■Are clothes coming out of the Refresh cycle with damp or wet spots?
Under certain environmental or installation conditions you may experience underdrying. Select the Touch Up cycle
(20 min. default time), which can be customized by selecting High temperature and/or additional cycle time by pressing the Timed Cycle Adjust More Time button.
Cycle time too short
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer. Failure to do so can result in back or other injury.
■Is the automatic cycle ending early?
The load may not be contacting the sensor strips. Level the dryer.
Change the dryness level setting on Automatic Cycles. Increasing or decreasing the dryness level will change the amount of drying time in a cycle.
Do not use a dryer rack with an Automatic Cycle.
Lint on load
■Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
■Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added to a partially dried load can temporarily stain your garments. Do not use fabric softener sheets with SteamCare cycles.
■Drum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to other clothing.
Loads are wrinkled
■Was the load removed from dryer at the end of the cycle? Select Touch Up Cycle to tumble the load with water and heat to help smooth out wrinkles from a load left in the dryer.
■Was the dryer overloaded?
Dry smaller loads that can tumble freely. Smaller loads of
■Loads are still wrinkled following SteamCare cycle? Make sure water is connected to the dryer. Check that water inlet hose is connected to both the faucet and dryer’s water inlet valve. Check that the water supply is turned on. This cycle is best for smoothing out wrinkles and reducing odors from loads consisting of
NOTE: Refer to garment care label instructions. Dry clean only garments are not recommended.
Odors
■Have you recently been painting, staining or varnishing in the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry the clothing.
■Is water connected to the dryer?
Check that water inlet hose is connected to both the faucet and dryer’s water inlet valve. Check that the water supply is turned on.
■To remove odors left in garments after wearing, select Refresh Cycle for small loads of
24