Suunto 110.9772 manual Options, Modifiers

Page 19

When using Timed Dry/Air Dry

Check that coverings are securely stitched.

Shake and fluff pillows by hand periodically during the cycle.

Dry item completely. Foam rubber pillows are slow to dry.

EXPRESS DRY™

Use this cycle for drying small loads or loads that need a short drying time.

Rack Dry

Press the Rack Dry button to use this cycle with the drying rack to dry clothes or items with low heat without tumbling. See “TUMBLE FREE™ Heated Dryer Rack.”

Timed Preset Cycle Settings

Timed Cycles

Default

Default Time

Load Type

Temperature

(Minutes)

 

 

 

TIMED DRY

High

40

Heavyweight, bulky items,

 

 

bedspreads, work clothes

 

 

 

 

 

EXPRESS DRY™

High

23

Small loads

 

 

 

 

 

RACK DRY

Low

30

Dry without tumbling

 

 

Options

You can customize your cycles by selecting options. Not all Options are available with all cycles. Current selections will glow green. If an option is unavailable with a selected cycle, the light will not illuminate when pressed and an error sound will be heard.

WRINKLE GUARD®

WRINKLE GUARD® helps smooth out wrinkles that form when you cannot unload the dryer promptly at the end of a cycle. During this option, the dryer stops tumbling and then tumbles again for a brief period.

Press WRINKLE GUARD® to get up to 2¹⁄₂ hours of heat-free, periodic tumbling at the end of a cycle.

Stop WRINKLE GUARD® at any time by pressing WRINKLE GUARD® or opening the dryer door.

For the Casual cycle, WRINKLE GUARD® is preset to ON. The other cycles will retain the WRINKLE GUARD® setting. For example, if you select WRINKLE GUARD® in the Normal cycle, WRINKLE GUARD® will be on the next time you select the Normal cycle.

NOTE: If you do not select WRINKLE GUARD®, the dryer stops after cool down.

Damp Dry Signal

Select the Damp Dry Signal to alert you that your clothes are approximately 80% dry. This is useful when you want to remove lightweight items in a mixed load to avoid overdrying or remove partially dry items that may need ironing.

The Damp Dry Signal is useful when drying bedsheets/linens in a mixed load or large items in the “Bulky/Bedding” cycle. When the signal goes off, open the door to stop the dryer, rearrange the load inside the dryer, close the door and restart the dryer to finish the drying cycle. Rearranging the load will aid in the drying process.

For the “Bulky/Bedding” cycle, the Damp Dry Signal is preset to ON.

NOTE: The Damp Dry Signal is available only with the Auto Cycles.

Button Sounds

You can change the volume of the sound of the beeps. Press BUTTON SOUNDS until the desired volume (Loud, Soft or Off) glows. The Power and Cancel buttons will still beep softly when the Button Sounds volume is set to Off.

Drum Light

Press Drum Light to turn on the light inside the dryer drum. During a cycle, if Drum Light is selected, the drum light turns on and will remain on until DRUM LIGHT is pressed again, the door is open and closed, or the door is left open for 5 minutes.

When the dryer is not running, the drum light will turn on when DRUM LIGHT is pressed or the dryer door is opened, and it will remain on until the dryer door has been open for 5 minutes, the dryer door is closed or DRUM LIGHT is pressed again.

Press DRUM LIGHT at any time to turn the drum light ON or OFF.

Modifiers

Use Modifiers to select time and temperature for the Touch Up Cycle. You may select dryness level for Automatic Cycles. Not all Modifiers are available with all options and cycles. Available modifier settings will glow amber. Current selections will glow green. If a modifier is unavailable with a selected cycle, the light will not illuminate.

Time

Press MORE TIME or LESS TIME until the desired drying time is displayed. The time cannot be changed with Auto Cycles.

19

Image 19
Contents Gas Dryer Kenmore Elite Appliance Warranty Table of ContentsYour safety and the safety of others are very important Dryer SafetyTools and Parts Installation InstructionsParts supplied Parts needed Installation clearancesOptional Pedestal Location RequirementsRecessed or closet installation Dryer on pedestal Dryer DimensionsInstallation spacing for cabinet installation Closet installation Dryer onlyElectrical Requirements Mobile home additional installation requirementsDimensions shown are for the recommended spacing Mobile home installations requireGas Supply Requirements Venting Requirements If using an existing vent systemIf this is a new vent system Vent material Plan Vent System Optional exhaust installationsAlternate installations for close clearances Special provisions for mobile home installationsConnect Vent Install Vent SystemInstall Leveling Legs Vent system chartLevel Dryer Connect Inlet HoseMake Gas Connection Indicated screws Reverse Door SwingRemove the door Reverse the hingeReinstalling the door Complete InstallationReverse the door handle To use an Auto Cycle Dryer USEStarting Your Dryer If the dryer will not start, check the followingStopping Your Dryer Pausing or RestartingControl Locked Status Lights Drying and Cycle TipsCycles Heavy Duty Auto Dry Preset Cycle SettingsSteamCare Preset Cycle Settings JeansModifiers OptionsTumble Free Heated Dryer Rack End of Cycle SignalAs needed cleaning Cleaning the Dryer LocationCleaning the Lint Screen Every load cleaningVacation, Storage and Moving Care Cleaning the Dryer InteriorRemoving Accumulated Lint Water Inlet HosesDryer Operation TroubleshootingLoads are wrinkled Cycle time too shortLint on load Stains on load or drumProtection Agreements Sears Installation ServiceMaster Protection Agreements Page USO DE LA Secadora ÍndiceGarantía Limitada DE UN AÑO Garantía DE LOS Electrodomésticos Kenmore EliteSu seguridad y la seguridad de los demás es muy importante Seguridad DE LA SecadoraPinzas Cinta para medir Instrucciones DE InstalaciónHerramientas y piezas Piezas suministradasUsted necesitará Pedestal opcionalRequisitos de ubicación Piezas necesariasInstalación en el clóset Sólo secadora Dimensiones de la secadoraEspacios para la instalación Espacio para la instalación en el clósetLas instalaciones en casas rodantes necesitan Requisitos eléctricosRequisitos del suministro de gas Si éste es un nuevo sistema de ventilación Requisitos de ventilaciónEl tubo de gas de la secadora Si usa un sistema de ventilación existenteInstalaciones alternas para espacios limitados Instalaciones opcionales de escapeVentilación Cuadro del sistema de ventilación Instalación del sistema de ventilaciónInstalación de las patas niveladoras Determinación de la vía del ducto de escapeConexión de las mangueras de entrada Conexión del ducto de escapePara su uso en casas rodantes Conexión del suministro de gas Nivelación de la secadoraQuite la puerta Inversión del cierre de la puertaDesmontaje de la puerta Inversión de la bisagraReinstalación de la puerta Inversión de la manija de la puertaSi la secadora no funciona, revise lo siguiente Solución de problemasDe problemas Complete la instalaciónPara usar un ciclo automático Auto Cycle Para hacer cambios durante un ciclo automáticoUSO DE LA Secadora Puesta en marcha de la secadoraCómo funciona el secado automático Auto Dry Para usar un ciclo de Cuidado con vapor SteamCarePara usar un ciclo programado Timed Cycle Luces de estado Pausa o reanudación de la marchaControl bloqueado Control Locked Sugerencias de ciclos y secadoCiclos Ciclos programados Timed Cycles Revitalizado Refresh con Cuidado de vapor SteamCareRetoque Touch Up con Cuidado de vapor SteamCare Ajustes prefijados del ciclo de Cuidado con vapor SteamCareLuz del tambor Drum Light Señal de secado húmedo Damp Dry SignalOpciones Sonidos de los botones Button SoundsCambio de ciclos, opciones y Modificadores ModificadoresSeñal de fin de ciclo Señal de fin de ciclo End of Cycle SignalEstante térmico de la secadora Limpieza del interior de la secadora Cuidado DE LA SecadoraLimpieza del lugar donde está La secadora Limpieza del filtro de pelusaCambio de la luz del tambor Mangueras de entrada de aguaFuncionamiento de la secadora Solución DE ProblemasResultados de la secadora Ropa arrugada El tiempo del ciclo es demasiado cortoPelusa en la ropa Manchas en la carga o en el tamborContratos maestros de protección Contratos DE ProtecciónServicio de Instalación de Sears W10136974B