Maytag W10150622A, W10150623A Troubleshooting, Vacation and Moving Care, Changing the Drum Light

Page 27

Vacation and Moving Care

Vacation care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

Moving care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Make sure leveling legs are secure in dryer base.

3.Use masking tape to secure dryer door.

For direct-wired dryers:

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Disconnect power.

2.Disconnect wiring.

3.Make sure leveling legs are secure in dryer base.

4.Use masking tape to secure dryer door.

Changing the Drum Light

The dryer light automatically turns on inside the dryer drum when you open the door.

To change the drum light

1.Unplug dryer or disconnect power.

2.Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover. Remove the cover.

3.Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only. Replace the cover and secure with the screw.

4.Plug in dryer or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call...

In U.S.A. www.maytag.com/help - In Canada www.maytag.ca

Dryer Operation

Dryer will not run

Has a household fuse blown, or has a circuit breaker tripped?

There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

Is the correct power supply available?

Electric dryers require 240-volt power supply. Check with a qualified electrician.

Was a regular fuse used? Use a time-delay fuse.

Is the dryer door firmly closed?

Was the Start button firmly pressed?

Large loads may require pressing and holding the Start button for 2-5 seconds.

No heat

Has a household fuse blown, or has a circuit breaker tripped?

The drum may be turning, but you may not have heat. Electric dryers use 2 household fuses or circuit breakers. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

27

Image 27
Contents W10150622A Sécheuse ÉlectriqueTable DES Matières Table of ContentsYour safety and the safety of others are very important Dryer SafetyInstallation Instructions Tools and PartsLocation Requirements Electrical Requirements U.S.A. Only If your outlet looks like this If connecting by direct wireElectrical Requirements Canada Only Power Supply Cord Direct Wire Style 1 Power supply cord strain reliefElectrical Connection U.S.A. Only Style 2 Direct wire strain relief Wire connection Direct Wire Wire connection Power Supply Cord12.7 BDE CG F Optional 3-wire connection If using an existing vent system Venting RequirementsIf this is a new vent system Vent material Clamps Plan Vent SystemSpecial provisions for mobile home installations Install Vent SystemAlternate installations for close clearances Vent system chartInstall Leveling Legs Connect VentLevel Dryer Reverse the strike Remove the door assemblyReinstall the door Reverse Door SwingIf the dryer will not start, check the following Complete InstallationU.S.A CanadaTo use a Sensor Dry Cycle Press Power Dryer USEStarting Your Dryer To restart the dryer Stopping, Pausing or RestartingDrying and Cycle Tips To stop or pause your dryer at any timeCycles Status LightsModifiers End of Cycle Signal OptionsChanging Cycles, Modifiers Options To use the drying rack Changing the Preset Dryness Level SettingsDrying Rack Option Changing Modifiers and Options after pressing StartDryer Care Cleaning the Dryer LocationCleaning the Lint Screen Cleaning the Dryer InteriorDryer Operation TroubleshootingVacation and Moving Care Changing the Drum LightDryer Results Unusual soundsDryer displaying code message Loads are wrinkled Cycle time too shortLint on load Stains on load or drumCanada Assistance or ServiceAccessories U.S.AONE Year Limited Warranty Maytag Corporation Major Appliance WarrantyVotre sécurité et celle des autres est très importante Sécurité DE LA SécheusePièces nécessaires Instructions D’INSTALLATIONOutillage et pièces Pièces fourniesDégagements de séparation à respecter Exigences d’emplacementDimensions de la sécheuse Il vous faudra’est à l’utilisateur qu’incombe la responsabilité de Linstallation dans une maison mobile exigeExigences concernant lévacuation En cas dutilisation du système dévacuation existantEn cas de nouveau système dévacuation Planification du système d’évacuation Brides de serrageÉvacuation Autres installations où le dégagement est réduit Déterminer litinéraire dacheminement du conduitTableau des systèmes dévacuation Réglage de laplomb de la sécheuse Installation du système d’évacuationInstallation des pieds de nivellement Raccordement du conduit d’évacuationInversion du sens douverture de la porte Dépose de la porteInversion de la gâche Réinstallation de la porte Si la sécheuse ne démarre pas, vérifier ce qui suit Achever linstallationMise en marche de la sécheuse Utilisation DE LA SécheuseArrêt, pause ou remise en marche Pour mettre la sécheuse en pause ou larrêter à tout momentPour remettre la sécheuse en marche Témoins lumineux Conseils pour le séchage et les programmesProgrammes Modificateurs Changement des programmes après avoir appuyé sur Start Signal de fin de programmeSignal de fin de programme Damp Dry Chime sonnerie indiquant un séchage humideJouets rembourrés ou oreillers Option de grille de séchageUtilisation de la grille de séchage Séchage sur grille Réglage Temp Durée Chandails en laineNettoyage de l’intérieur de la sécheuse Nettoyage de lemplacement de la sécheuseEntretien DE LA Sécheuse Nettoyage du filtre à charpieRetrait de la charpie accumulée DéménagementChangement de l’ampoule d’éclairage Du tambour Sons inhabituels DépannageFonctionnement de la sécheuse Absence de chaleurLe filtre à charpie est-il obstrué de charpie? La sécheuse est-elle installée dans un placard?Résultats de la sécheuse Temps de programme trop courtAssistance OU Service AccessoiresAu Canada Garantie DES Gros Appareils Ménagers Maytag Corporation W10150622A SP PN W10150623A