Humminbird ICE 45, ICE 35 manual Assembling the Portable Bag ICE 55 Only

Page 15

3. Assembling the Portable Bag (ICE 55 Only)

In this procedure, you will install the ICE 55 Flasher into the portable bag. The portable bag is not included with ICE 35/45 Flashers.

1.Unzip the largest opening on the front of the portable bag.

2.Insert the base/handle assembly into the portable bag, so that the Flasher Dial is facing out of the bag. For best results, pull the bag over one shoulder of the handle at a time.

3.Adjust the bag so that you can easily grab the handle, through the fabric handhold inset, from the outside top of the portable bag.

Installing the Base

Pulling the Bag

Holding the

into the Bag

over the Handle

Portable Bag

11

Image 15
Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Specifications Contact Humminbird MaintenanceTroubleshooting Year Limited Warranty Humminbird Service PolicyReal Time Sonar HOW Sonar WorksPage Page HOW ICE Flashers Work Installation Overview Repeat steps 2-5 for the second cable retentionarm ICE Flasher Series Base AssemblyAssembling the Transducer Storage Posts Slide one spring over each flat-headscrew and set asideAssembling the Base and Handle Installing the Handle Onto the Base Sliding in the HandleRepeat for the other side Assembling the Control Head to the Base and HandleICE Flasher Series Assembly Connecting the Power CableCharging and Installing the Battery Spade Battery Terminals Slide the Battery Terminal Adapter over each spade terminalAssembling the Portable Bag ICE 55 Only Assembling the Transducer and Float Transducer InstallationTesting the Transducer Prior to Installation This procedure you willassemblethe transducerand floatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Powering UP the Control Head SimulatorWHAT’S on the Flasher Dial Page KEY Functions WHAT’S on the Active Display ICE 45/55 onlyPOWER/RANGE Dial Range scales for the ICE 35 are shown below Selection DialZoom Gain ICE Noise Rejection= 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55 BeamPress the Beam key to toggle between 240 kHz and 455 kHz See Palette 1, Palette 2, or Palette 3 for more information Palette1 ICE 35/45/55Palette2 ICE 55 Only Orange Palette3 ICE 55 OnlyTarget ICE 55 Only Dual Mode KEY Functions Maintenance ICE Flasher Series MaintenanceTransducer Maintenance ICE Flasher Series Fishfinder Doesn’t Power Up TroubleshootingYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page By e-mail Contact Humminbird