Humminbird ICE 45, ICE 55 Transducer Installation, Testing the Transducer Prior to Installation

Page 16

TRANSDUCER INSTALLATION

Perform the following high-level steps by following the instructionsin each numbered section to install the transducer.

1.Testing the transducer

2.Assembling the transducer and float

3.Connecting the cable

1. Testing the Transducer Prior to Installation

Prior to installation, test the transducer to make sure that no damage occurred during shipping.

1.Connectthe transducer to the control head. The slots are keyed to prevent reverse installation, so be careful not to force the connector into the holder.

2.Drop the transducer into the ice hole. If the transducer is working properly, you will see the bottom displayed on the Flasher Dial as a red line.

WARNING: Before walking onto the ice, make sure that conditions are safe.

2. Assembling the Transducer and Float

In this procedure you willassemblethe transducerand float.

Attaching the Float to

the Support Cable

Float

Signal

Cable

Support

Cable

Cable

Support

Clip

1.Thread the support cable through the support clip and then clip onto the transducer.

2.Attach your transducer float to the support cable by sliding the support cable through the slit in the float.

NOTE: Attaching the float is optional. You can also use the storage posts to hold the support cable in position.

Threading Support

Cable through

Support Clip

Transducer

12

Image 16

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Maintenance TroubleshootingYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview ICE Flasher Series Base Assembly Assembling the Transducer Storage PostsSlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideConnecting the Power Cable ICE Flasher Series AssemblyCharging and Installing the Battery Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only Transducer Installation Testing the Transducer Prior to InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Simulator Powering UP the Control HeadWHAT’S on the Flasher Dial Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICEBeam = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Press the Beam key to toggle between 240 kHz and 455 kHz Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions ICE Flasher Series Maintenance MaintenanceTransducer Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail