Humminbird ICE 35, ICE 55, ICE 45 manual Test and Finish the Installation

Page 20

TEST AND FINISH THE INSTALLATION

Once you have assembled both the ICE Flasher Series™controlhead and the Ice Fishing transducer, and have routed all the cables, you should perform a final test. Testing should be performed with the transducer in the water.

1.After connecting the transducer to the control head, and confirming that the power cable is connected to the battery, drop the transducer into the ice hole to confirm proper operation.

WARNING: Before walking onto the ice, make sure that conditions are safe.

2. Turn the Power/Range dial to A (Auto) or x1 to power-on the control head.

NOTE: If the unit does not power up, make sure that the connector is fully seated in the back of the control head, the power cable is connected to the battery, and the battery is charged.

3.If all connections are correct and power is available, the Humminbird® control head will enter Normal operation, and you should see the bottom on the control head display.

4.If the bottom is visible on-screen with a digital depth readout, the unit is working properly (ICE 35 will only display the bottom on the Flasher Dial).

NOTE: The transducer must be submerged in water for reliable transducer detection. The bottom of the transducer should be even with the bottom of the ice or hang slightly below the bottom of the ice.

16

Image 20

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Maintenance TroubleshootingYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview ICE Flasher Series Base Assembly Assembling the Transducer Storage PostsSlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideCharging and Installing the Battery ICE Flasher Series AssemblyConnecting the Power Cable Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only Transducer Installation Testing the Transducer Prior to InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder WHAT’S on the Flasher Dial Powering UP the Control HeadSimulator Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICEPress the Beam key to toggle between 240 kHz and 455 kHz = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Beam Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions Transducer Maintenance MaintenanceICE Flasher Series Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail