Humminbird ICE 55, ICE 45, ICE 35 manual ICE Flasher Series Maintenance, Transducer Maintenance

Page 36

MAINTENANCE

To keep both your ICE Flasher Series™ control head and your transducer working properly, perform the followingmaintenance tasks as needed.

ICE FLASHER SERIES™ MAINTENANCE

If your ICE Flasher Series™ unit comes into contact with salt spray, simply wipe the affected surfaces with a cloth dampened in fresh water. Do not use a chemical glass cleaner on the lens, as chemicals in the solution may cause cracking in the lens. When cleaning the LCD protective lens, use a chamois and non-abrasive, mild cleaner. Do not wipe while dirt or grease is on the lens. Be careful to avoid scratchingthe lens.

WARNING: Never leave your ICE Flasher Series™ Fishfinder in a closed car or trunk; the extremely high temperatures generated in hot weather can damage the electronics.

TRANSDUCER MAINTENANCE

If your transducer remains out of the water for a long period of time, it may take some time to wet the transducerafter it is returned to the water. Small air bubbles can cling to the surface of the transducerand interfere with proper operation. These bubbles will dissipate with time, or you may wipe the face of the transducerwith your fingers after the transducer is in the water.

32

Image 36
Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Maintenance TroubleshootingYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview ICE Flasher Series Base Assembly Assembling the Transducer Storage PostsSlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideICE Flasher Series Assembly Connecting the Power CableCharging and Installing the Battery Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only Transducer Installation Testing the Transducer Prior to InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Powering UP the Control Head SimulatorWHAT’S on the Flasher Dial Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICE= 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55 BeamPress the Beam key to toggle between 240 kHz and 455 kHz Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions Maintenance ICE Flasher Series MaintenanceTransducer Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail