Humminbird ICE 55, ICE 45, ICE 35 manual Installation Overview

Page 9

INSTALLATION OVERVIEW

Before you start installation, we encourage you to read these instructions carefully in order to get the full benefit from your ICE Flasher Series™ Fishfinder. You will assemble your control head first, then assemble and install your transducer. When you are done with both of these installation tasks, you should perform a final installation test before operating your ICE Flasher Series™ Fishfinder.

Please make sure that the following parts are included for your ICE Flasher Series™ control head:

•ICE Flasher Series™ control head

•Portable base and handle

•Power cable, battery, battery charger,and connecting hardware

•Flasher Bag (ICE 55 only)

Also, please make sure the following parts are included for your transducer:

•Ice Fishing transducer with 8' of signal cable

•Float, 40" of support cable, and support clip

•Cable clamps.

In addition to the hardware supplied, you will need a Phillips-head and a flat-head screwdriver for installation and operation.

5

Image 9

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Troubleshooting MaintenanceYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdReal Time Sonar HOW Sonar WorksPage Page HOW ICE Flashers Work Installation Overview Assembling the Transducer Storage Posts ICE Flasher Series Base AssemblySlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmAssembling the Base and Handle Installing the Handle Onto the Base Sliding in the HandleRepeat for the other side Assembling the Control Head to the Base and HandleICE Flasher Series Assembly Connecting the Power CableCharging and Installing the Battery Spade Battery Terminals Slide the Battery Terminal Adapter over each spade terminalAssembling the Portable Bag ICE 55 Only Testing the Transducer Prior to Installation Transducer InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Powering UP the Control Head SimulatorWHAT’S on the Flasher Dial Page KEY Functions WHAT’S on the Active Display ICE 45/55 onlyPOWER/RANGE Dial Range scales for the ICE 35 are shown below Selection DialZoom Gain ICE Noise Rejection= 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55 BeamPress the Beam key to toggle between 240 kHz and 455 kHz See Palette 1, Palette 2, or Palette 3 for more information Palette1 ICE 35/45/55Palette2 ICE 55 Only Orange Palette3 ICE 55 OnlyTarget ICE 55 Only Dual Mode KEY Functions Maintenance ICE Flasher Series MaintenanceTransducer Maintenance ICE Flasher Series Fishfinder Doesn’t Power Up TroubleshootingYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page By e-mail Contact Humminbird