Humminbird ICE 35, ICE 55, ICE 45 manual Noise Rejection, Ice

Page 29

NOISE REJECTION

Noise Rejection allows you to reduce cross-talk interference from neighboring fishfinders that are operatingon the same frequency as your ICE Flasher Series™ Fishfinder.

If two nearby units are operating on the same frequency, your ICE Flasher Series™ Fishfinder display might show results from the neighboringfishfinder.

NOTE: Your other option is to use the Beam key to switch to a different operating frequency (see Beam for more information).

1.Press the Noise key.

2.Turn the Selection dial to choose a particular noise rejection setting, then press the Selection dial to complete your selection.

NOTE: If you do not press the Selection dial within 5 seconds of pressing the Noise key or turning the Selection dial, the noise select function will time out.

NOTE: If your control head beeps repeatedly as you turn the Selection dial, you have reached the lowest or highest level possible for the Noise Rejection.

Noise RejectionSetting

Noise RejectionSetting

ICE 35

The Noise Rejection setting is displayed as a narrow or wide blue line at the top of the Flasher Dial. (1 - 10, where Narrow = 1, and Wide = 10; Default = 6)

ICE 45/55

The Noise Rejection setting is shown on the Active Display. (1 - 10, Default = 6)

25

Image 29

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Troubleshooting MaintenanceYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdReal Time Sonar HOW Sonar WorksPage Page HOW ICE Flashers Work Installation Overview Assembling the Transducer Storage Posts ICE Flasher Series Base AssemblySlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmAssembling the Base and Handle Installing the Handle Onto the Base Sliding in the HandleRepeat for the other side Assembling the Control Head to the Base and HandleCharging and Installing the Battery ICE Flasher Series AssemblyConnecting the Power Cable Spade Battery Terminals Slide the Battery Terminal Adapter over each spade terminalAssembling the Portable Bag ICE 55 Only Testing the Transducer Prior to Installation Transducer InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder WHAT’S on the Flasher Dial Powering UP the Control HeadSimulator Page KEY Functions WHAT’S on the Active Display ICE 45/55 onlyPOWER/RANGE Dial Range scales for the ICE 35 are shown below Selection DialZoom Gain ICE Noise RejectionPress the Beam key to toggle between 240 kHz and 455 kHz = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Beam See Palette 1, Palette 2, or Palette 3 for more information Palette1 ICE 35/45/55Palette2 ICE 55 Only Orange Palette3 ICE 55 OnlyTarget ICE 55 Only Dual Mode KEY Functions Transducer Maintenance MaintenanceICE Flasher Series Maintenance ICE Flasher Series Fishfinder Doesn’t Power Up TroubleshootingYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page By e-mail Contact Humminbird