Humminbird ICE 45, ICE 35 manual Palette3 ICE 55 Only, Orange

Page 33

Palette Number

NOTE: The location of an object in relation to the transducer can influence how it appears on the Flasher Dial. For example, a large object might display as a weak sonar return signal if it is located on the outer edges of the transducer beam, where as a small object located at the top of the transducer beam mightdisplay as a strong sonar return signal.

Palette3 (ICE 55 Only)

If you have a high-end ICE 55 Flasher, you will also have the choice of Color Palette 3, which is a 6-color palette.

Red

Strong Signal

Dense, large objects such as fish, thick vegetation, or hard bottom, are usually displayed as thick or thin red lines on the Flasher Dial. In Palette 3, Red indicates a strong sonar return signal.

Orange

Fairly Strong Signal

Indicates a sonar return signal with an intensity in between Red and Yellow.

Yellow

Medium Signal

Small objects such as fish, sparse vegetation, or soft bottom (sand or mud) are usually displayed as yellow lines on the Flasher Dial. In Palette 3, Yellow indicates a medium sonar return signal.

Light Green

Fairly Weak Signal

Indicates a sonar return signal with an intensity in between Yellow and Green.

Green

Weak Signal

Light objects and softer bottoms such as your jig, bait fish, sparse vegetation, are displayed as green lines on the Flasher Dial. In Palette3, Green indicates a weak sonar return signal.

Blue

Very Weak Signal

Indicates a sonar return signal with an intensity less than Green.

29

Image 33
Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Troubleshooting MaintenanceYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdReal Time Sonar HOW Sonar WorksPage Page HOW ICE Flashers Work Installation Overview Assembling the Transducer Storage Posts ICE Flasher Series Base AssemblySlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmAssembling the Base and Handle Installing the Handle Onto the Base Sliding in the HandleRepeat for the other side Assembling the Control Head to the Base and HandleICE Flasher Series Assembly Connecting the Power CableCharging and Installing the Battery Spade Battery Terminals Slide the Battery Terminal Adapter over each spade terminalAssembling the Portable Bag ICE 55 Only Testing the Transducer Prior to Installation Transducer InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Powering UP the Control Head SimulatorWHAT’S on the Flasher Dial Page KEY Functions WHAT’S on the Active Display ICE 45/55 onlyPOWER/RANGE Dial Range scales for the ICE 35 are shown below Selection DialZoom Gain ICE Noise Rejection= 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55 BeamPress the Beam key to toggle between 240 kHz and 455 kHz See Palette 1, Palette 2, or Palette 3 for more information Palette1 ICE 35/45/55Palette2 ICE 55 Only Orange Palette3 ICE 55 OnlyTarget ICE 55 Only Dual Mode KEY Functions Maintenance ICE Flasher Series MaintenanceTransducer Maintenance ICE Flasher Series Fishfinder Doesn’t Power Up TroubleshootingYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page By e-mail Contact Humminbird