Humminbird ICE 35, ICE 55, ICE 45 manual Dual Mode KEY Functions, Ice

Page 35

DUAL MODE KEY FUNCTIONS

There are several additional functions that you may use by holding and pressing certain keys. Additional features include:

Backlight: Press and hold the Gain key to turn on and off the backlightfor night fishing and to save battery power - ICE 45 and 55 only. (On, Off; Default = Off)

Units: Press and hold the Noise key in order to change the units of measure from feet to meters or back again - ICE 45 and 55 only. (feet, meters; Default = feet)

Battery: Press and hold the Beam key in order to see the percentage of power left on the battery.

The battery status will display on the Flasher Dial for approximately 5 seconds, and then the Flasher Dial will resume Normal operation.

Voltage Will Flash When the Battery is Empty

%

Battery Gauge

Percentageof

Empty

Green Line Indicating

Battery Power

Percentageof Battery Power

 

ICE 35

The percentage of battery power is indicated on the battery gauge, which is located on the bottom of the Range Scale. A green line will be displayed between E and F to indicate the percentage on the battery gauge. When the battery is empty, the line will turn red. (On, Off, Default = Off)

ICE 45/55

The percentage of battery power is shown on the Active Display. When the battery is empty,the Voltage icon will flash. (On, Off, Default = Off)

31

Image 35
Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Specifications Contact Humminbird MaintenanceTroubleshooting Year Limited Warranty Humminbird Service PolicyReal Time Sonar HOW Sonar WorksPage Page HOW ICE Flashers Work Installation Overview Repeat steps 2-5 for the second cable retentionarm ICE Flasher Series Base AssemblyAssembling the Transducer Storage Posts Slide one spring over each flat-headscrew and set asideAssembling the Base and Handle Installing the Handle Onto the Base Sliding in the HandleRepeat for the other side Assembling the Control Head to the Base and HandleCharging and Installing the Battery ICE Flasher Series AssemblyConnecting the Power Cable Spade Battery Terminals Slide the Battery Terminal Adapter over each spade terminalAssembling the Portable Bag ICE 55 Only Assembling the Transducer and Float Transducer InstallationTesting the Transducer Prior to Installation This procedure you willassemblethe transducerand floatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder WHAT’S on the Flasher Dial Powering UP the Control HeadSimulator Page KEY Functions WHAT’S on the Active Display ICE 45/55 onlyPOWER/RANGE Dial Range scales for the ICE 35 are shown below Selection DialZoom Gain ICE Noise RejectionPress the Beam key to toggle between 240 kHz and 455 kHz = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Beam See Palette 1, Palette 2, or Palette 3 for more information Palette1 ICE 35/45/55Palette2 ICE 55 Only Orange Palette3 ICE 55 OnlyTarget ICE 55 Only Dual Mode KEY Functions Transducer Maintenance MaintenanceICE Flasher Series Maintenance ICE Flasher Series Fishfinder Doesn’t Power Up TroubleshootingYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page By e-mail Contact Humminbird