Humminbird ICE 35, ICE 55, ICE 45 manual Specifications

Page 41

SPECIFICATIONS

Depth Capability	200 ft (60 m)
Power Cable Length	11", 28cm
Operating Frequency	240 kHz / 455 kHz
Flasher Dial Resolution	526
Number of Colors	ICE 35/45: 3
	ICE 55: 6
Area of Coverage	240 kHz: 19° @ -3 dB
	455 kHz: 9° @ -3 dB
Power Requirement	10.5-20 VDC
Power Output (RMS)	ICE 35: 100 W
	ICE 45: 225 W
	ICE 55: 300 W
Power Output (Peak to Peak)	ICE 35: 800 W
	ICE 45: 1800 W
	ICE 55: 2400 W
Display	ICE 45/55: Liquid Crystal Diode (LCD)
Unit Housing	High-Impact Plastic
Transducer	XI 9 19
Transducer Cable Length	8 ft (2.4m)

NOTE: Humminbird® verifies maximum stated depth in saltwater conditions, but actual depth performance may vary due to transducer installation, water type, thermal layers, bottom composition and slope.

NOTE: Product specifications and features are subject to change without notice.

ENVIRONMENTALCOMPLIANCESTATEMENT: It is the intention of Humminbird® to be a responsible corporate citizen, operating in compliance with known and applicable environmental regulations, and a good neighbor in the communities where we make or sell our products.

37

Image 41

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Troubleshooting MaintenanceYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdReal Time Sonar HOW Sonar WorksPage Page HOW ICE Flashers Work Installation Overview Assembling the Transducer Storage Posts ICE Flasher Series Base AssemblySlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmAssembling the Base and Handle Installing the Handle Onto the Base Sliding in the HandleRepeat for the other side Assembling the Control Head to the Base and HandleCharging and Installing the Battery ICE Flasher Series AssemblyConnecting the Power Cable Spade Battery Terminals Slide the Battery Terminal Adapter over each spade terminalAssembling the Portable Bag ICE 55 Only Testing the Transducer Prior to Installation Transducer InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder WHAT’S on the Flasher Dial Powering UP the Control HeadSimulator Page KEY Functions WHAT’S on the Active Display ICE 45/55 onlyPOWER/RANGE Dial Range scales for the ICE 35 are shown below Selection DialZoom Gain ICE Noise RejectionPress the Beam key to toggle between 240 kHz and 455 kHz = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Beam See Palette 1, Palette 2, or Palette 3 for more information Palette1 ICE 35/45/55Palette2 ICE 55 Only Orange Palette3 ICE 55 OnlyTarget ICE 55 Only Dual Mode KEY Functions Transducer Maintenance MaintenanceICE Flasher Series Maintenance ICE Flasher Series Fishfinder Doesn’t Power Up TroubleshootingYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page By e-mail Contact Humminbird