Humminbird ICE 45 manual ICE Flasher Series Base Assembly, Assembling the Transducer Storage Posts

Page 10

ICE FLASHER SERIES™ BASE ASSEMBLY

Perform the following high-level steps by following the instructionsin each numbered section to assemble the ICE Flasher Series™ base assembly:

1.Assembling the transducer storage posts

2.Assembling the base and handle

3.Assembling the control head to the base and handle

1. Assembling the Transducer Storage Posts

In this procedureyou will install the posts to hold the transducer cable.

Nut
Keyed Space of
Cable Retention Arm
Storage Post	Cable Retention
	Cable Retention
	Arm, facing out
Spring
Flat Head Screw

1.Slide one spring over each flat-headscrew and set aside.

2.Insert a nut into the keyed space of each cable retention arm. Push down on the nut until it is flush with the surface of the cable retention arm.

3.Slide one cable retention arm over one storage post so that the arm faces out.

4.Hold the cable retention arm in place, and turn the base upside down.

5.Drop the assembled screw and spring straight into the back of the storage post. Using a flat-head screwdriver,push down on the screw, and tighten.

6.Repeat steps 2-5 for the second cable retentionarm.

6

Image 10

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Year Limited Warranty Humminbird Service Policy MaintenanceTroubleshooting Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview Slide one spring over each flat-headscrew and set aside ICE Flasher Series Base AssemblyAssembling the Transducer Storage Posts Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideConnecting the Power Cable ICE Flasher Series AssemblyCharging and Installing the Battery Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only This procedure you willassemblethe transducerand float Transducer InstallationTesting the Transducer Prior to Installation Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Simulator Powering UP the Control HeadWHAT’S on the Flasher Dial Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICEBeam = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Press the Beam key to toggle between 240 kHz and 455 kHz Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions ICE Flasher Series Maintenance MaintenanceTransducer Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail