Humminbird ICE 35, ICE 55, ICE 45 manual Slide the Battery Terminal Adapter over each spade terminal

Page 14

Spade

Battery

Terminals

 

Foam Pad

NOTE: Do NOT connect the power cable to the battery at this time. You should wait until just before fishing to connect the power cable to the battery.

3.Movethe tie-down strapsout of the way so that the batterywellis fullyaccessible.

4.Hold the foam pad and the battery together,and slide them into the battery well. Make sure that the spade terminals are on the left side of the battery well and the foam pad fits evenly around the battery well edges.

Installing the Battery

Tying Down the Battery

5. Pull the two battery tie-down straps over the top of the battery and connect both ends of each strap over the top. Make sure that the straps are pulled tight around the battery and that the battery is seated securely in the battery well.

6. Slide the Battery Terminal Adapter over each spade terminal.

NOTE: The Battery Terminal Adapter allows you to power your control head and charge it at the same time.

10

Image 14
Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Year Limited Warranty Humminbird Service Policy MaintenanceTroubleshooting Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview Slide one spring over each flat-headscrew and set aside ICE Flasher Series Base AssemblyAssembling the Transducer Storage Posts Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideCharging and Installing the Battery ICE Flasher Series AssemblyConnecting the Power Cable Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only This procedure you willassemblethe transducerand float Transducer InstallationTesting the Transducer Prior to Installation Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder WHAT’S on the Flasher Dial Powering UP the Control HeadSimulator Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICEPress the Beam key to toggle between 240 kHz and 455 kHz = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Beam Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions Transducer Maintenance MaintenanceICE Flasher Series Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail