Humminbird ICE 35, ICE 45 manual Palette2 ICE 55 Only

Page 32

Palette Number

NOTE: The location of an object in relation to the transducer can influence how it appears on the Flasher Dial. For example, a large object might display as a weak sonar return signal if it is located on the outer edges of the transducer beam, where as a small object located at the top of the transducerbeam mightdisplay as a strong sonar return signal.

Palette2 (ICE 55 Only)

If you have a high-end ICE 55 Flasher, you will also have the choice of Palette 2 to display your sonar data.

Red

Strong Signal

Dense, large objects such as fish, thick vegetation, or hard bottom, are usually displayed as thick or thin red lines on the Flasher Dial. In Palette 2, Red indicates a strong sonar return signal.

Green

Medium Signal

Small objects such as fish, sparse vegetation, or soft bottom (sand or mud) are usually displayed as green lines on the Flasher Dial. In Palette 2, Green indicates a medium sonar return signal.

Yellow

Weak Signal

Light objects such as your jig, bait fish, sparse vegetation, and sometimes microscopic activity or turbulence are displayed as yellowlines on the Flasher Dial. In Palette 2, Yellowindicates a weak sonar return signal.

28

Image 32
Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Maintenance TroubleshootingYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview ICE Flasher Series Base Assembly Assembling the Transducer Storage PostsSlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideCharging and Installing the Battery ICE Flasher Series AssemblyConnecting the Power Cable Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only Transducer Installation Testing the Transducer Prior to InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder WHAT’S on the Flasher Dial Powering UP the Control HeadSimulator Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICEPress the Beam key to toggle between 240 kHz and 455 kHz = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Beam Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions Transducer Maintenance MaintenanceICE Flasher Series Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail