Humminbird ICE 55 Assembling the Control Head to the Base and Handle, Repeat for the other side

Page 12

3. Assembling the Control Head to the Base and Handle

In this procedure you will install the ICE Flasher Series™ control head to the base/handle assembly.

1.Place the control head into the gimbal bracket located on the base.

2.Place the 1" diameter black washers as shown in the figure; then, thread the gimbal knob through the bracket and washers, into the housing. Tighten the gimbal knob to secure the ICE Flasher Series™ control head to the mount.

3.Repeat step 2 for the other side.

Washer

Knob

Washer

Base Arm

8

Image 12

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Maintenance TroubleshootingYear Limited Warranty Humminbird Service Policy Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview ICE Flasher Series Base Assembly Assembling the Transducer Storage PostsSlide one spring over each flat-headscrew and set aside Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideICE Flasher Series Assembly Connecting the Power CableCharging and Installing the Battery Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only Transducer Installation Testing the Transducer Prior to InstallationThis procedure you willassemblethe transducerand float Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Powering UP the Control Head SimulatorWHAT’S on the Flasher Dial Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICE= 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55 BeamPress the Beam key to toggle between 240 kHz and 455 kHz Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions Maintenance ICE Flasher Series MaintenanceTransducer Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail