Humminbird ICE 55, ICE 45, ICE 35 manual Connecting the Transducer Cable

Page 18

3. Connecting the Transducer Cable

This section covers how to connect your transducer cable to your control head.

NOTE: If you have an ICE 55 Flasher, remove the control head and base from the portable bag first.

1.Insert the transducer cable into the appropriate terminal slot on the rear of the control head.

NOTE: The slots are keyed to prevent reversed installation, so be careful not to force the connector onto the holder.

2.Route the transducersignal cable beneath the control head and secure to cable clips on the base.

Connecting to the ICE Flasher Series™ Fishfinder

Transducer

Signal Cable

Cable

Clips

3.Reinstall assembled control head, base, and transducer into portable bag (ICE 55 only).

14

Image 18

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Year Limited Warranty Humminbird Service Policy MaintenanceTroubleshooting Specifications Contact HumminbirdHOW Sonar Works Real Time SonarPage Page HOW ICE Flashers Work Installation Overview Slide one spring over each flat-headscrew and set aside ICE Flasher Series Base AssemblyAssembling the Transducer Storage Posts Repeat steps 2-5 for the second cable retentionarmInstalling the Handle Onto the Base Sliding in the Handle Assembling the Base and HandleAssembling the Control Head to the Base and Handle Repeat for the other sideICE Flasher Series Assembly Connecting the Power CableCharging and Installing the Battery Slide the Battery Terminal Adapter over each spade terminal Spade Battery TerminalsAssembling the Portable Bag ICE 55 Only This procedure you willassemblethe transducerand float Transducer InstallationTesting the Transducer Prior to Installation Assembling the Transducer and FloatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder Powering UP the Control Head SimulatorWHAT’S on the Flasher Dial Page WHAT’S on the Active Display ICE 45/55 only KEY FunctionsPOWER/RANGE Dial Selection Dial Range scales for the ICE 35 are shown belowZoom Gain Noise Rejection ICE= 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55 BeamPress the Beam key to toggle between 240 kHz and 455 kHz Palette1 ICE 35/45/55 See Palette 1, Palette 2, or Palette 3 for more informationPalette2 ICE 55 Only Palette3 ICE 55 Only OrangeTarget ICE 55 Only Dual Mode KEY Functions Maintenance ICE Flasher Series MaintenanceTransducer Maintenance Troubleshooting ICE Flasher Series Fishfinder Doesn’t Power UpYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page Contact Humminbird By e-mail