Humminbird ICE 35, ICE 55, ICE 45 manual Assembling the Base and Handle

Page 11

2. Assembling the Base and Handle

In this procedure, you will install the handle onto the base, and attach the tie-down straps that will be used to secure the battery to the base in a later procedure.

1.Install the handle onto the base, so that the curved part of the handle faces towards the back of the base, towards the battery well. Use the four included #8-32 x 7/16" screws, two on each side, to attach the handle to the base (see the illustrations Installing the Handle Onto the Base and Sliding in the Handle). Hand tighten only!

Installing the Handle Onto the Base	Sliding in the Handle

NOTE: The handle is keyed so that it only fits onto the base in one direction.

2.Turn the base upside down, then threadthe two includedbattery tie-downstraps from the bottom of the base up through each side of the battery well, using the strap holes (see the illustration Attaching the Battery Tie-Down Straps).

Attaching the Battery Tie-Down Straps

Battery

Tie-downStraps

7

Image 11

Contents ICE 35, ICE 45, ICE Installation and Operations Manual Thank YOU Table of Contents Specifications Contact Humminbird MaintenanceTroubleshooting Year Limited Warranty Humminbird Service PolicyReal Time Sonar HOW Sonar WorksPage Page HOW ICE Flashers Work Installation Overview Repeat steps 2-5 for the second cable retentionarm ICE Flasher Series Base AssemblyAssembling the Transducer Storage Posts Slide one spring over each flat-headscrew and set asideAssembling the Base and Handle Installing the Handle Onto the Base Sliding in the HandleRepeat for the other side Assembling the Control Head to the Base and HandleCharging and Installing the Battery ICE Flasher Series AssemblyConnecting the Power Cable Spade Battery Terminals Slide the Battery Terminal Adapter over each spade terminalAssembling the Portable Bag ICE 55 Only Assembling the Transducer and Float Transducer InstallationTesting the Transducer Prior to Installation This procedure you willassemblethe transducerand floatIce Layer Float Transducer Connecting the Transducer Cable Storing the Transducer Test and Finish the Installation Getting Started Using Your ICE Flasher Series Fishfinder WHAT’S on the Flasher Dial Powering UP the Control HeadSimulator Page KEY Functions WHAT’S on the Active Display ICE 45/55 onlyPOWER/RANGE Dial Range scales for the ICE 35 are shown below Selection DialZoom Gain ICE Noise RejectionPress the Beam key to toggle between 240 kHz and 455 kHz = 455 kHz, and Wide = 240 kHz Default = Wide ICE 45/55Beam See Palette 1, Palette 2, or Palette 3 for more information Palette1 ICE 35/45/55Palette2 ICE 55 Only Orange Palette3 ICE 55 OnlyTarget ICE 55 Only Dual Mode KEY Functions Transducer Maintenance MaintenanceICE Flasher Series Maintenance ICE Flasher Series Fishfinder Doesn’t Power Up TroubleshootingYear Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Which your product was purchased Page By e-mail Contact Humminbird