E6581429
2.After selecting the position of a figure you want to change, specify/confirm a value with the control dial.
(In this example, 30.0Hz is specified.)
Functions of function keys
The functions keys allow you to select the position or decimal place of each figure (operation frequency) you want to increment or decrement with the control dial.
F1 : Selects the position of 1000 times of minimum setting unit.
F2 : Selects the position of 100 times of minimum setting unit.
Basic Parameters
FC
Panel frequency
| Output frequency |
| 0.0Hz |
| |
|
| 30.0Hz |
|
| |
| min=0.0 |
|
| max=60.0 |
|
|
|
| ×10 |
|
|
| ×1000 | ×100 | ×1 |
| |
F3 : Selects the position of 10 times of minimum setting unit. | F1 | F2 | F3 | F4 |
F4 : Selects the position of minimum setting unit (In this case, 0.1).
When you confirm the value specified, the screen goes back to the top window of Top View Mode.
3 | Q To change the frequency during operation |
| |
| Press the control dial during operation to display the operation panel operation frequency menu and turn the control |
| dial to change the setting. |
| 3.3.2 Using an EASY key function |
| The [F1] function key can be used as a substitute for the EASY key described in the manual E6581386 5.22. The |
| name of the function assigned to the [F1] key is displayed in the lower left corner of the window, and the [F1] key can |
| be used as the EASY key. |
“Quick” | : Quick mode / standard setting mode switching |
| (F750=0) |
“Loc/Rem” | : Local / Remote key (F750=2) |
“Update” | : Monitor peak / minimum hold trigger (F750=3) |
*Shortcut key function (F750=1) cannot be used. Even if the parameter is set so, the name of the function is not displayed on the screen.
(1) Quick mode / standard setting mode switching function
Top View Mode
| FWD | 60.0 Hz | STOP | |
|
|
|
| 0.0 Hz |
|
|
|
|
|
| Quick | Lng | ||
|
|
|
| |
|
|
|
|
|
|
|
|
| |
Quick |
|
| ||
Loc/Rem
Update
<Standard Setting mode is selected at power on (parameter PSEL=0)>
•When power is turned on, ”Quick” is displayed. ([F1] key is in OFF State) In this case, top window of Parameter Setup Mode is ordinary one.
•If the [F1] key is pressed while “Quick” is displayed, it turns to highlighted “ Quick ”. ([F1] key is in ON State) In this case, the Quick mode window appears as the top window of Parameter Setup Mode.
<Quick mode is selected at power on (parameter PSEL=1)>
•When power is turned on, highlighted “ Quick ” is displayed. ([F1] key is in OFF State)
In this case, the Quick mode window appears as the top window of Parameter Setup Mode.
•If the [F1] key is pressed while “ Quick ” is displayed, it turns to normal “Quick”. ([F1] key is in ON State) In this case, top window of Parameter Setup Mode is ordinary one.
<Always Quick mode (parameter PSEL=2)>
•Highlighted “ Quick ” is displayed.
The Quick mode window appears as the top window of Parameter Setup Mode.
*In this case, [F1] key is not active.