Toro SA41 Minimum Charge Display, Switching Between READINGS, Minimum CHARGE, and Diagnostics

Page 22

MINIMUM CHARGE DISPLAY

Access to the next 5 screens is from the “Readings” screen.

Hold the “Down” and “Up” keys simultaneously for approximately 1 second, then release the keys.

Min Charge: 67%

In Batt Today

Min Charge: 67%

In Batt This Wk

Weeks go: 1

Min Charge: 76%

Days ago: 1

Min Charge: 76%

End Min Charge

Back to "Readings"

SWITCHING BETWEEN READINGS, MINIMUM CHARGE, AND DIAGNOSTICS

Readings

Press UP and Down together for 1 second

Minimum charge

displays

Press UP and Down together for 1 second

Diagnostic

Displays

Pressing NEXT DISPLAY will return to Readings

22

Image 22

Contents Selectronic Australia Installation Warranty CardIntroduction Connection of AC and DC Wiring SupplyRED = Battery Positive + Black = Battery Negative Energy Management Status Standby Inverter OFF Inverter on Status ResetOperation StatusWhere the Optional 200 AMP Current Shunt is Installed Minimum Charge Controller Outputs SettingsOn with OFF Set Control On with on On with Time Set Control Lockout DurationBuzzer Lockout More SettingsBuzzer on / OFF SET DAYLockout Alarm Input AC Volts SettingAlarm Inputs Current Shunt Settings External ShuntMinimum Charge in Battery Battery CapacityCharge in Battery LOW Charge AlarmOverload Shutdown and Alarms Alarm 2 Active Fault FindingAlarm 1 Active Heatsink TOO HOTInverter Shuts Down with LOW Volts SA41 Maintenance System MaintenanceBattery Maintenance SA41 Electrical Specifications Demand Start SectionRadio Frequency Interference Handy HintHeatsink Temperature Appendix I DiagnosticsTransformer Temperature Demand Start CurrentAppendix II Flow Diagram for Displays and Settings Minimum Charge Display Switching Between READINGS, Minimum CHARGE, and DiagnosticsDiagnostic Displays Minimum charge DisplaysINV CO, LO A/H or CO+LAHFrom previous General Appendix III SA Inverter OptionsSA-SB-01 Interface KIT Alarm Inputs Examples SA-SB-01 Interface ConnectionsInstallation of SA-KP-01 Optional Keypad Ext. Keypad no Set ParametersExt. Shunt no Set Parameters Installation of SA-S200 Optional Current ShuntAmps 0.0A OUT Battery Zero DC Amps OFF Set ParametersProduct Warranty Conditions Mounting Template for SA-KP-01 Keypad