Toro SA41 owner manual Mounting Template for SA-KP-01 Keypad

Page 30

MOUNTING TEMPLATE FOR SA-KP-01 KEYPAD

Use this template when marking and cutting holes in plasterboard, etc., for the SA-KP-01 keypad.

30

Image 30

Contents Selectronic Australia Warranty Card InstallationIntroduction Connection of AC and DC Wiring SupplyRED = Battery Positive + Black = Battery Negative Energy Management Status Standby Inverter OFF Inverter on Status ResetOperation StatusWhere the Optional 200 AMP Current Shunt is Installed Minimum Charge Settings Controller OutputsOn with OFF Set Control On with on On with Time Set Control Lockout DurationBuzzer Lockout More SettingsBuzzer on / OFF SET DAYLockout Alarm Input AC Volts SettingAlarm Inputs Current Shunt Settings External ShuntMinimum Charge in Battery Battery CapacityCharge in Battery LOW Charge AlarmOverload Shutdown and Alarms Alarm 2 Active Fault FindingAlarm 1 Active Heatsink TOO HOTInverter Shuts Down with LOW Volts System Maintenance SA41 MaintenanceBattery Maintenance SA41 Electrical Specifications Demand Start SectionRadio Frequency Interference Handy HintHeatsink Temperature Appendix I DiagnosticsTransformer Temperature Demand Start CurrentAppendix II Flow Diagram for Displays and Settings Minimum Charge Display Switching Between READINGS, Minimum CHARGE, and DiagnosticsDiagnostic Displays Minimum charge DisplaysINV CO, LO A/H or CO+LAHFrom previous Appendix III SA Inverter Options GeneralSA-SB-01 Interface KIT Alarm Inputs Examples SA-SB-01 Interface ConnectionsInstallation of SA-KP-01 Optional Keypad Ext. Keypad no Set ParametersExt. Shunt no Set Parameters Installation of SA-S200 Optional Current ShuntAmps 0.0A OUT Battery Zero DC Amps OFF Set ParametersProduct Warranty Conditions Mounting Template for SA-KP-01 Keypad