Toro SA41 Buzzer on / OFF, Buzzer Lockout, More Settings, Set Day, SET Hour Time of DAY

Page 10

BUZZER ON / OFF

Buzzer : ON

[Set Parameters]

BUZZER LOCKOUT

Buzzer Lockout : OFF

[Set Parameters]

MORE SETTINGS

Any key to end

or DOWN for more

SET DAY

Day : MON

[Set Parameters]

This display allows you to select whether the audio alarm sounds during an overload or other alarm conditions. If set to OFF the buzzer will not sound during an alarm condition. The alarm condition will still be displayed. Pressing the UP or DOWN keys will change the setting.

If set to ON, lockout prevents the buzzer from sounding during the lockout period. See lockout on page 11. Pressing the UP or DOWN keys will change the setting.

Pressing NEXT DISPLAY or UP keys will save the settings entered and go back to ‘Displays’. If the DOWN key is pressed, more settings will be displayed.

Sets the current Day. Use the UP and DOWN keys to set the value.

SET HOUR (TIME OF DAY)

Hour : 15

[Set Parameters]

Set the hours in the current time of day (24 hour time). Use the UP or DOWN keys to set the value.

SET MINUTE (TIME OF DAY)

Minute : 30

[Set Parameters]

Sets the minutes in the current time of day. Use the UP or DOWN keys to set the value.

DEMAND START SENSE

DS Sense : 6W

[Set Parameters]

This sets the minimum load which will bring the SA41 ON when the inverter Status is set to STANDBY mode (demand start or pulsing). See page 5. In most cases the default setting of 6W would be suitable. If there is a load which the SA41 won't sense then reduce this value until the SA41 starts. Alternatively if there is a small load that keeps the SA41 on then increase this value. You may need to try a few different settings to find the most appropriate value for your installation. Use the UP or DOWN keys to set the value.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Selectronic Australia Installation Warranty CardIntroduction Connection of AC and DC Wiring SupplyRED = Battery Positive + Black = Battery Negative Energy Management Status Standby Inverter OFF Inverter on Status ResetOperation StatusWhere the Optional 200 AMP Current Shunt is Installed Minimum Charge Controller Outputs SettingsOn with OFF Set Control On with on On with Time Set Control Lockout DurationBuzzer Lockout More SettingsBuzzer on / OFF SET DAYLockout Alarm Input AC Volts SettingAlarm Inputs Current Shunt Settings External ShuntMinimum Charge in Battery Battery CapacityCharge in Battery LOW Charge AlarmOverload Shutdown and Alarms Alarm 2 Active Fault FindingAlarm 1 Active Heatsink TOO HOTInverter Shuts Down with LOW Volts SA41 Maintenance System MaintenanceBattery Maintenance SA41 Electrical Specifications Demand Start SectionRadio Frequency Interference Handy HintHeatsink Temperature Appendix I DiagnosticsTransformer Temperature Demand Start CurrentAppendix II Flow Diagram for Displays and Settings Minimum Charge Display Switching Between READINGS, Minimum CHARGE, and DiagnosticsDiagnostic Displays Minimum charge DisplaysINV CO, LO A/H or CO+LAHFrom previous General Appendix III SA Inverter OptionsSA-SB-01 Interface KIT Alarm Inputs Examples SA-SB-01 Interface ConnectionsInstallation of SA-KP-01 Optional Keypad Ext. Keypad no Set ParametersExt. Shunt no Set Parameters Installation of SA-S200 Optional Current ShuntAmps 0.0A OUT Battery Zero DC Amps OFF Set ParametersProduct Warranty Conditions Mounting Template for SA-KP-01 Keypad
Top Page Image Contents