Toro SA41 owner manual Lockout, Duration

Page 9

On with : INV CO

[Set Control 1]

On with : LO A/H

[Set Control 1]

On with : CO+LAH

[Set Control 1]

(Inverter Cut out) The control 1 output will turn on when the inverter shuts down due to overload, over temperature or low or high voltage.

The output will remain on for the time set in "Duration", below.

The output will not come on if the front panel circuit beaker is tripped.

(Low Amp-Hours) If the charge in the batteries falls below the level set in the "Minimum Charge" setting (see page 13), then the control output will come on, for the time set in "Duration", below.

(Cutout or Low Amp-Hours) This setting combines the previous two, bring the output on with low amp hours, or with the inverter cutting out.

The output will stay on for the time set in "Duration", below.

Note that the controller can only be set to LO A/H and CO+LAH if the optional external current shunt kit (SA-S200) is used. Each controller output is capable of switching an external relay or contactor which can be used to switch AC or DC loads.

If the controller is set to INV CO, LO A/H or CO+LAH and the condition still exists after the "Duration" time, the output will stay on until the condition ends. Also with these settings a "Lockout" option can be set ON or OFF. (See lockout below and on page 11)

LOCKOUT

Lockout: ON

[Set Control 1]

DURATION

Duration : 4 Hrs [Set Control 1]

If set to ON, lockout prevents the controller output coming on during the lockout period. (See notes on lockout on page 11.) Pressing the UP or DOWN keys will change the setting.

This screen sets the duration hours the control 1 output will stay on. Pressing the UP or DOWN keys will change the setting.

Duration : 30 Min

[Set Control 1]

This screen sets the duration minutes the control 1 output will stay on. Pressing the UP or DOWN keys will change the setting.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Selectronic Australia Warranty Card InstallationIntroduction Supply Connection of AC and DC WiringRED = Battery Positive + Black = Battery Negative Operation Status Standby Inverter OFF Inverter on Status ResetEnergy Management StatusWhere the Optional 200 AMP Current Shunt is Installed Minimum Charge Settings Controller OutputsOn with OFF Set Control On with on On with Time Set Control Duration LockoutBuzzer on / OFF More SettingsBuzzer Lockout SET DAYLockout Alarm Inputs AC Volts SettingAlarm Input Current Shunt Settings External ShuntCharge in Battery Battery CapacityMinimum Charge in Battery LOW Charge AlarmOverload Shutdown and Alarms Alarm 1 Active Fault FindingAlarm 2 Active Heatsink TOO HOTInverter Shuts Down with LOW Volts System Maintenance SA41 MaintenanceBattery Maintenance Demand Start Section SA41 Electrical SpecificationsHandy Hint Radio Frequency InterferenceTransformer Temperature Appendix I DiagnosticsHeatsink Temperature Demand Start CurrentAppendix II Flow Diagram for Displays and Settings Diagnostic Displays Switching Between READINGS, Minimum CHARGE, and DiagnosticsMinimum Charge Display Minimum charge DisplaysCO+LAH INV CO, LO A/H orFrom previous Appendix III SA Inverter Options GeneralSA-SB-01 Interface KIT SA-SB-01 Interface Connections Alarm Inputs ExamplesExt. Keypad no Set Parameters Installation of SA-KP-01 Optional KeypadAmps 0.0A OUT Battery Installation of SA-S200 Optional Current ShuntExt. Shunt no Set Parameters Zero DC Amps OFF Set ParametersProduct Warranty Conditions Mounting Template for SA-KP-01 Keypad
Top Page Image Contents