Toro SA41 owner manual INV CO, LO A/H or, Co+Lah

Page 23

SETTINGS

Access is from “Readings” screen.

Hold down “Next Display” key for approximately 1 second.

ON or OFF		On with: TIME
		[Set Control 1]


		Start Day: SUN
		[Set Control 1]


		Start Hour: 16
		[Set Control 1]


		Start Min: 30
		[Set Control 1]

Duration: 4 Hrs

[Set Control 1]

Duration: 30 Min

[Set Control 1]

CONTROL OUTPUT 2

SET AS FOR OUTPUT 1

Buzzer: ON

[Set Parameters]

Buzz Lockout: OFF

[Set Parameters]

DS Sense: 6W

[Set Parameters]

Any key to end

or DOWN for more

Day: MON

[Set Parameters]

Hour: 15

[Set Parameters]

Minute: 30

[Set Parameters]

Continue on to next page

INV CO, LO A/H or

CO+LAH

Lockout: ON

[Set Control 1]

Back to

"Readings"

if DOWN

not pressed.

23

Image 23

Contents Selectronic Australia Introduction Warranty CardInstallation Supply Connection of AC and DC WiringRED = Battery Positive + Black = Battery Negative Status Status Standby Inverter OFF Inverter on Status ResetOperation Energy ManagementWhere the Optional 200 AMP Current Shunt is Installed Minimum Charge On with OFF Set Control On with on On with Time Set Control SettingsController Outputs Duration LockoutSET DAY More SettingsBuzzer on / OFF Buzzer LockoutLockout Current Shunt Settings External Shunt AC Volts SettingAlarm Inputs Alarm InputLOW Charge Alarm Battery CapacityCharge in Battery Minimum Charge in BatteryOverload Shutdown and Alarms Heatsink TOO HOT Fault FindingAlarm 1 Active Alarm 2 ActiveInverter Shuts Down with LOW Volts Battery Maintenance System MaintenanceSA41 Maintenance Demand Start Section SA41 Electrical SpecificationsHandy Hint Radio Frequency InterferenceDemand Start Current Appendix I DiagnosticsTransformer Temperature Heatsink TemperatureAppendix II Flow Diagram for Displays and Settings Minimum charge Displays Switching Between READINGS, Minimum CHARGE, and DiagnosticsDiagnostic Displays Minimum Charge DisplayCO+LAH INV CO, LO A/H orFrom previous SA-SB-01 Interface KIT Appendix III SA Inverter OptionsGeneral SA-SB-01 Interface Connections Alarm Inputs ExamplesExt. Keypad no Set Parameters Installation of SA-KP-01 Optional KeypadZero DC Amps OFF Set Parameters Installation of SA-S200 Optional Current ShuntAmps 0.0A OUT Battery Ext. Shunt no Set ParametersProduct Warranty Conditions Mounting Template for SA-KP-01 Keypad