Toro SA41 owner manual From previous

Page 24

From previous page

Lockout on: 22:00 [Set Parameters]

L'out off: 6:00

[Set Parameters]

Lo Volt Trip: YES [Set Parameters]

Lo DC Volts: 40.0 [Set Parameters]

Lo DCV on: 48.0 [Set Parameters]

Hi DC Volts: 68.0 [Set Parameters]

AC Volts: 240V

[Set Parameters]

Alarm1 active:HI [Set Parameters]

Alarm2 active:HI [Set Parameters]

Ext. Keypad: YES [Set Parameters]

Ext. Shunt: YES [Set Parameters]

Back to "Readings" if no Current Shunt

YES

Zero DC Amps:OFF

[Set Parameters]

Capacity: 500AH [Set Parameters]

AH In Batt: 445

[Set Parameters]

Min Charge: 60% [Set Parameters]

Lo Chg Alarm:OFF

[Set Parameters]

Batt Effic.:95%

[Set Parameters]

End Settings

[Set Parameters]

Back to "Readings"

24

Image 24

Contents Selectronic Australia Warranty Card InstallationIntroduction Connection of AC and DC Wiring SupplyRED = Battery Positive + Black = Battery Negative Status Standby Inverter OFF Inverter on Status Reset OperationEnergy Management StatusWhere the Optional 200 AMP Current Shunt is Installed Minimum Charge Settings Controller OutputsOn with OFF Set Control On with on On with Time Set Control Lockout DurationMore Settings Buzzer on / OFFBuzzer Lockout SET DAYLockout AC Volts Setting Alarm InputsAlarm Input Current Shunt Settings External ShuntBattery Capacity Charge in BatteryMinimum Charge in Battery LOW Charge AlarmOverload Shutdown and Alarms Fault Finding Alarm 1 ActiveAlarm 2 Active Heatsink TOO HOTInverter Shuts Down with LOW Volts System Maintenance SA41 MaintenanceBattery Maintenance SA41 Electrical Specifications Demand Start SectionRadio Frequency Interference Handy HintAppendix I Diagnostics Transformer TemperatureHeatsink Temperature Demand Start CurrentAppendix II Flow Diagram for Displays and Settings Switching Between READINGS, Minimum CHARGE, and Diagnostics Diagnostic DisplaysMinimum Charge Display Minimum charge DisplaysINV CO, LO A/H or CO+LAHFrom previous Appendix III SA Inverter Options GeneralSA-SB-01 Interface KIT Alarm Inputs Examples SA-SB-01 Interface ConnectionsInstallation of SA-KP-01 Optional Keypad Ext. Keypad no Set ParametersInstallation of SA-S200 Optional Current Shunt Amps 0.0A OUT BatteryExt. Shunt no Set Parameters Zero DC Amps OFF Set ParametersProduct Warranty Conditions Mounting Template for SA-KP-01 Keypad