Baldor MIN1853 manual Edit Menu, New Program

Edit Menu		Pressing the EDIT key displays a set of sub–menus.
	Action			Display			Comments
Press EDIT key							Select a sub–menu, press F1 (PROG),
				–↑EDIT↓	–
							F2 (SETUP), or F3 (POS).
			PROG	SETUP		POS
Press ↑ or ↓
	key for more sub						Select a sub–menu, press F1 (LIST).
				–↑EDIT↓	–
menu selections.
			LIST

Edit, PROG Submenu Create A New Program

1.Press “EDIT, F1 (PROG)” and you will see a display with a blinking cursor as shown in Figure 4-2.

Figure 4-2 New Program

–↑EDIT PROGRAM↓ –

>_

2.Enter an unused identifying number for the program (between 1–400). (If several programs are stored, you may need to scroll the list to determine a number that has not been used. )

Note: You may assign a name, rather than a number, to your program if you wish. See “Naming Your Programs” later in this section.

3.Press ENTER. You will see a blank screen with a blinking cursor in the upper left corner. The program editor is now ready to accept a program.

4.Once inside the program editor, enter commands by pressing a function key and then a numeric key. Examples of creating, saving, naming, and editing programs follow.

Example of entering programming commands found on the #2 key, Figure 4-3.

STo enter the VE command (the upper command on the number 2 key), press F1 (blue) then press the number 2 key.

STo enter the AC command (the middle command on the number 2 key), press F2 (yellow) then press the number 2 key.

STo enter the DE command (the lower command on the number 2 key), press F3 (green) then press the number 2 key.

Figure 4-3

DEF VE

AC

2DE

4-4Keypad Operation MN1853