Baldor MIN1853 manual Configure End of Travel Switch Polarity, Configure JOG Parameters

Configure End of Travel Switch Polarity

Configuring Motor Type [ ET ]

EDIT > SETUP > I/O > LIMITS

Value: NORM CLOSED

Range: NORM OPEN or NORM CLOSED

Allows selection of Normally Open or Normally Closed polarity of the End of Travel switch (EOT). Use ↑↓ to select the definition.

Configure JOG Parameters

– Axis One EOT POL – ←↑ NORM CLOSED ↓→

Select value, press ENTER

The keypad provides a convenient way to jog the motor. The parameters that control your jog operation are configured using the JOG SETUP menu:

Action		Display		Comments
Press F2 (JOG) for more sub				Select a sub–menu, press F1 (I/O), F2
		–↑SETUP↓ –
menu selections.				(JOG), or F3 (HOME).
	I/O	JOG	HOME
Press ↓ key for more sub menu				Select a sub–menu, press F1 (ACCEL),
	–↑JOG SETUP↓ –
selections.				F2 (LO–VEL), or F3 (HI–VEL).
	ACCEL	LO–VEL HI–VEL
				Select a sub–menu, press F1
	–↑JOG SETUP↓ –
				(ENABLE)
	ENABLE

Configuring JOG Acceleration [ JAr ]

EDIT > SETUP > JOG > ACCEL

Value: 0.1 {Accel Units}

Range: 0.0–9999999.0

Sets the acceleration and deceleration used during a jog move. Use the numeric keys to enter a value (units were selected in the SETUP > MECH > ACCEL menu).

Configuring JOG Low Velocity [ JLr ]

EDIT > SETUP > JOG > LO–VEL

Value: 0.1 {Velocity Units}

Range: 0.0–9999999.0

Sets the low speed JOG velocity. Use the numeric keys to enter a value (units were selected in the SETUP > MECH > VEL menu).

– Axis One JOG Accel –

← 0.1 sec →

Select value, press ENTER

– Axis One JOG		Lo–Vel –
←	0.1 in/s	→

Select value, press ENTER

MN1853 Setup 5-13