Graco 3A1214B important safety instructions 21 in. 25 Cm 63 cm

Page 11

4.Install the height adjustment bracket (303) to the RoadPak mounting arms (304) with bolts (312), washers (307), and nuts (315).

315

307312

ti16912a

303

5.Use wrench to tighten all bolts to lock into place (torque to 28 ft-lb).

6.Install stow-bracket (302) to height adjustment bracket (303). Locate the bottom of the stow-bracket 21 in. to 25 in. (53cm - 63cm) from the ground. Ensure the stow-bracket is installed level.

302

21 in. - 25 in.

53 cm - 63 cm

ti16787a

Setup

NOTE: It is recommended to bolt the mounting bracket through the bed of the vehicle to the frame of the vehicle.

ti16916a

3A1214B

11

Image 11

Contents List of Models see Important Safety InstructionsComplete Assemblies ModelsFire and Explosion Hazard Equipment Misuse Hazard General Information Introduction and General InformationIntroduction Component Identification Component Function Charge Battery SetupFilter Orientation Single Hitch Mounting Bracket 24G626 Installation OptionGun Arm Bracket Mount Narrow Orientation RoadPak Mounting Bracket 24G627 Installation Option21 in. 25 Cm 63 cm Wide Orientation Gun Arm Installation 24G628, 24G629 Slide Beam Installation 24G630705 Hose Routing to Pumps and Tanks Hose Connection Hose RoutingElectrical Cable Connections Install Winch Kit Optional Install Front Pointer InstructionsInstall and Align Front Mechanical Guidance System Optional Install and Align Video Guidance System OptionalBead System Pressure Relief Pressure Relief ProcedureOperation RPS 2900 Pump Fluid Pressure ReliefPrepare System to Paint Set Up Slide Beam and Gun ArmInitial Settings Load Reflecting MaterialsSafe Range cold Select/Prime Pumps Start EngineTurn on Bead System Begin to SprayPrime Guns Flushing the System Perform Pressure Relief Procedure, seeOperation RoadLazer in Storage Position Securing Gun Arm for TransportationTechnical Data Graco Information Graco Standard Warranty