Slide Beam Installation 24G630 | Graco 3A1214B specs

5.Install stow-bracket (302) to height adjustment bracket (303). Locate the bottom of the stow-bracket 21 in. to 25 in. (53cm - 63cm) from the ground. Ensure the stow-bracket is installed level.

ti16960a

302

21 in. - 25 in.

53 cm - 63 cm

ti16787a

NOTE: It is recommended to bolt the mounting bracket through the bed of the vehicle to the frame of the vehicle.

ti16916a

Slide Beam Installation (24G630)

The slide beam is 87.75 in. (2.2m) long. The Slide Beam is shipped to accommodate wider vehicles. The beam can be cut down to 75.75 in. (1.9m) long or 60 in. (1.5m) long to accommodate different vehicle sizes.

Setup

1.To shorten the beam to 75.75 in. long, cut 12 in. from the end the beam towards the next hole on the beam. To shorten the beam to 60 in., cut 27.75 in. from the end of the beam towards the third hole as shown below.

27.75in.

12 in.

ti16600a

2.After determining the desired length, slide the beam into the bracket on the channel.

ti16647a

Gun Arm Installation (24G628, 24G629)

1.Position the gun arm assembly next to the vehicle.

2.Pull the slide beam out to the side of the vehicle where the gun arm is located. Lift the gun arm and hold the traverse bracket in the position shown below. Slide the beam through the wheels so they are mounted on the track of the slide beam as shown below.

ti15959a

3A1214B