Graco 3A1214B important safety instructions Start Engine, Select/Prime Pumps

Page 22

Operation

Start Engine

Gasoline is extremely flammable and explosive under certain conditions. Fuel could spray from the fuel line connector when it is disconnected from engine. Fuel could come in contact with the hot muffler and cause fire or explosion. To reduce the risk of fire or explosion, always vent the fuel tank and allow engine muffler to cool before you disconnect the fuel line.

1.Set POWER ON/OFF on Programmable Skipline Controller to ON.

2.Set engine to choke position ON.

3.Set throttle to half speed and turn key.

2.Slowly turn pressure control clockwise until pump begins to stroke.

ti16922a

3.When flushing fluid comes out of return lines, set hydraulic valve to OFF position.

ti15838a

4. After engine starts, set choke to OFF.

Select/Prime Pumps

1. Open hydraulic valve to activate pumps.

4. Place suction hoses in paint drums.

ti16645a

5. Open hydraulic valve to activate pumps.

ti16920a

ti16920a

22

3A1214B

Image 22
Contents Important Safety Instructions List of Models seeModels Complete AssembliesFire and Explosion Hazard Equipment Misuse Hazard Introduction Introduction and General InformationGeneral Information Component Identification Component Function Setup Charge BatteryGun Arm Bracket Mount Single Hitch Mounting Bracket 24G626 Installation OptionFilter Orientation RoadPak Mounting Bracket 24G627 Installation Option Narrow Orientation21 in. 25 Cm 63 cm Wide Orientation Slide Beam Installation 24G630 Gun Arm Installation 24G628, 24G629705 Hose Routing to Pumps and Tanks Hose Routing Hose ConnectionElectrical Cable Connections Install and Align Video Guidance System Optional Install Front Pointer InstructionsInstall and Align Front Mechanical Guidance System Optional Install Winch Kit OptionalRPS 2900 Pump Fluid Pressure Relief Pressure Relief ProcedureOperation Bead System Pressure ReliefLoad Reflecting Materials Set Up Slide Beam and Gun ArmInitial Settings Prepare System to PaintSafe Range cold Start Engine Select/Prime PumpsPrime Guns Begin to SprayTurn on Bead System Perform Pressure Relief Procedure, see Flushing the SystemOperation Securing Gun Arm for Transportation RoadLazer in Storage PositionTechnical Data Graco Standard Warranty Graco Information