Graco 3A1214B important safety instructions Equipment Misuse Hazard

Page 4

Warnings

WARNING

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

Do not operate the unit when fatigued or under the influence of drugs or alcohol.

Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS from distributor or retailer.

Do not leave the work area while equipment is energized or under pressure. Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.

Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manufacturer’s replacement parts only.

Do not alter or modify equipment.

Use equipment only for its intended purpose. Call your distributor for information.

Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

Do not kink or over bend hoses or use hoses to pull equipment.

Keep children and animals away from work area.

Comply with all applicable safety regulations.

CARBON MONOXIDE HAZARD

Exhaust contains poisonous carbon monoxide, which is colorless and odorless. Breathing carbon monoxide can cause death.

Do not operate in an enclosed area.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

Read MSDSs to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

BURN HAZARD

Equipment surfaces and fluid that’s heated can become very hot during operation. To avoid severe burns:

Do not touch hot fluid or equipment.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment to help protect you from serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and burns. This equipment includes but is not limited to:

Protective eyewear, and hearing protection.

Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.

4

3A1214B

Image 4
Contents Important Safety Instructions List of Models seeModels Complete AssembliesFire and Explosion Hazard Equipment Misuse Hazard Introduction Introduction and General InformationGeneral Information Component Identification Component Function Setup Charge BatteryGun Arm Bracket Mount Single Hitch Mounting Bracket 24G626 Installation OptionFilter Orientation RoadPak Mounting Bracket 24G627 Installation Option Narrow Orientation21 in. 25 Cm 63 cm Wide Orientation Slide Beam Installation 24G630 Gun Arm Installation 24G628, 24G629705 Hose Routing to Pumps and Tanks Hose Routing Hose ConnectionElectrical Cable Connections Install Front Pointer Instructions Install and Align Front Mechanical Guidance System OptionalInstall and Align Video Guidance System Optional Install Winch Kit OptionalPressure Relief Procedure OperationRPS 2900 Pump Fluid Pressure Relief Bead System Pressure ReliefSet Up Slide Beam and Gun Arm Initial SettingsLoad Reflecting Materials Prepare System to PaintSafe Range cold Start Engine Select/Prime PumpsPrime Guns Begin to SprayTurn on Bead System Perform Pressure Relief Procedure, see Flushing the SystemOperation Securing Gun Arm for Transportation RoadLazer in Storage PositionTechnical Data Graco Standard Warranty Graco Information