Setup
3.Attach the handle (702) to each end of the slide beam. Press the cotter pin (707) through the handle to hold it in place. Fasten nut (706) and bolt (705) through the slide beam on both ends to act as stops on the channel.
6.Lift gun arm to a vertical position and slide it over the stow bracket.
708
707
704
706
ti16422a
ti16662a | 705 |
4.Route hoses for the gun arm before moving arm to prevent hoses from being pinched.
7.Rest the gun arm on the stow bracket and position the stop to sit properly on the stow bracket. Slide the pin (321) through the gun arm bracket and stow bracket to secure the gun arm. Tighten the two bolts (579) down to lock the gun arm bracket into place.
ti16658a
5.Position gun arm at the end of the slide beam and secure the hose bundle to the height adjustment bracket with a rubber pad and hose clamp (320).
302
ti16788a
579
ti15837a
ti16918a
14 | 3A1214B |