Begin to Spray, Prime Guns, Turn on Bead System

6.When paint comes out of return lines, set hydraulic valve to OFF position.

7.Close all dump valves.

ti16551a

8. Place return lines into paint drum.

Prime Guns

1. Close air valve to pressurize air system.

ti16959a

2.Open only spray gun ball valves corresponding to paint pumps or color used. NOTE: Never open both ball valves on the two-color gun at the same time. Paint color contamination could result.

ti15657a

3.Turn guns on with Programmable Skipline Controller (see Skipline Controller manual).

4.Place an empty pail under spray guns to catch drainage from spray guns.

5.Set hydraulic valve(s) to ON position to activate pumps.

ti16920a

Operation

6.Turn off guns with Programmable Skipline Control- ler.

Turn on Bead System

1. Turn bead system valve to ON position.

ti16549a

2.Set desired bead tank pressure by turning regulator knob.

ti16910a

3.Remove and secure ground strap from earth ground.

4.System is now ready for painting. Select guns 1 or 2 with the Programmable Skipline Controller.

Begin to Spray

Select appropriate procedure from menu on RoadLazer control system. See Skipline Controller manual.

3A1214B