Setup
Setup
Charge Battery
If the battery is newly purchased or has not been used for a long time, charge it before you use it.
Installing RoadLazer Into Vehicle
The RoadPak can be mounted in the front or rear of the vehicle bed as well as in any orientation desired. The base of the RoadPak is 39.5 in. x 49.5 in. (1.0m x 1.25m).
RoadLazer needs to be properly secured to prevent it from moving during transportation and operation.
Paint drums are heavy and could shift from side to side when the vehicle is cornering. The paint drums could fall from the vehicle and cause injury or death. Secure the drums when the vehicle is in transport or spraying.
Paint could splash from the paint drum bung adapters when the paint drums are full and the vehicle is mov- ing. Do not overfill the paint drums.
RoadPak Installation (24G624, 24G625)
Load RoadPak into vehicle using a forklift or a hoist that is rated for the weight capacity of the RoadPak. For RoadPak weight information see Technical Data, page 27.
ti16442a
ti16665a
ti16653a
ti16654a
ti16664a
After mounting the RoadPak on the vehicle, firmly secure the RoadPak to the vehicle using the
ti16443a
ti16599a |
8 | 3A1214B |