Gun Arm Bracket Mount, Filter Orientation

Filter Orientation

After mounting and securing the RoadPak to the vehicle, position the filter assemblies as desired.

1.Use a hammer to loosen the large jam nut on the pump assembly.

ti16782a

2.Rotate the filter assembly to the desired orientation and use a hammer to tighten the jam nut and lock the assembly into place.

ti16783a

ti16784a

Gun Arm Bracket Mount

Single Hitch Mounting Bracket (24G626) Installation (Option 1)

ti15839a

1.Install hitch insert bracket (A) into receiver (C). Ensure hitch pin (B) goes through tightening rod hole (D).

ti16648a

A D C

B ti15955a

Setup

2.Tighten nut until the hitch insert bracket is pulled securely to the receiver and no play is seen between the two parts.

ti16785a

3.Install the height adjustment bracket (303) to the hitch insert bracket with bolts (312), washers (307), and nuts (315). Ensure the height adjustment bracket is installed level.

315 307

307

312

303	ti15956a

4.Install stow bracket (302) to height adjustment bracket (303) with bolts (312), washers (307), and nuts (315). Locate the bottom of the stow-bracket 21-in. to 25-in. (53cm - 63cm) from the ground. Ensure the stow-bracket is installed level.

315

307 312

302

21 in. - 25 in.

(53 cm - 63 cm)

ti15957a

3A1214B