Operation
Air System Pressure Relief
1.Relieve air pressure in air tank by turning air valve to OPEN position.
ti16961a
EMERGENCY SHUT OFF
To shut down the entire RoadLazer system, set POWER ON/OFF on the Programmable Skipline Controller to the OFF position.
Load Reflecting Materials
1.Set POWER ON/OFF on Programmable Skipline Controller to OFF.
2.Set RoadLazer engine ignition key to OFF.
3.Relieve air system pressure by opening ball valve until gauge reads 0.
4.Relieve air pressure in bead tank by turning bead system valve to OFF position.
5.Remove cover from bead tank.
6.Screen reflective materials to prevent debris from entering tank.
7.Load bead tank with reflective materials.
2.Pull slide beam to left or right side of vehicle. Lock slide beam clamps.
3.Remove gun arm from upright stowed position, and slide to end of boom. Slowly lower gun arm, and lock into position with clamp.
ti16423a
Prepare System to Paint
Initial Settings
1. Ground RoadLazer ground strap to earth ground.
TI3058A
2.Fill throat packing nut with TSL to prevent premature packing wear. Do this each time you spray and store.
Set Up Slide Beam and Gun Arm
1. Unlock gun arm clamp and slide beam clamps.
Approximate Fill Level
ti5240a
ti16425a
20 | 3A1214B |