
Oxygen Analyzer
3.2 | Mounting the Analyzer | 30 | |
3.3 | Rear Panel Connections | 32 | |
3.3.1 | Gas Connections | 32 | |
3.3.2 | Electrical Connections | 33 | |
| 3.3.2.1 Primary Input Power | 34 | |
| 3.3.2.2 | 34 | |
3.4 | Electrolyte Refill of BDS Sensor | 39 | |
3.5 | Testing the System | 40 | |
3.6 | Powering Up the System | 41 | |
Operation | ..................................................................................... | 42 | |
4.1 | Introduction | 42 | |
4.2 | The Analyzer application | 43 | |
4.3 | The System Screen | 44 |
4.3.1Communication Information and Calibration Parameters 44
4.3.2Setting Software Parameters: Filter, Gas Factor,
Tmp. Coeff. |
| 45 | ||
| 4.3.2.1 | The Digital Filter | 46 | |
| 4.3.2.2 | The Gas Factor | 46 | |
| 4.3.2.3 | Temperature Coefficient | 47 | |
| 4.3.2.4 | Set Defaults | 48 | |
4.4 | Calibration of the Analyzer | 49 | ||
4.4.1 | Zero Cal | 49 | ||
| 4.4.1.1 | Zero Failure | 50 | |
4.4.2 | Span Cal | 50 | ||
| 4.4.2.1 | Span Failure | 51 | |
4.5 | The Alarms Function | 51 | ||
4.6 | The Range Function | 53 | ||
4.6.1 | Setting the Analog Output Ranges | 53 | ||
4.6.2 | Fixed Range Analysis | 55 | ||
4.8 | Signal Output | 55 |
Teledyne Analytical Instruments | vii |