Invacare RPS350-1E manual Mounting Battery Charger Figure, Charging Batteries Figure

Page 8

OPERATION

O P E R A T I O N

Raising/Lowering Stand Up Lift (FIGURE 3)

RAISING THE LIFT. Press the UP (Ï) button on the hand control to raise the lift arms and the patient.

LOWERING THE LIFT. Press the DOWN (Ð) button on the hand control to lower the lift arms and the patient.

NOTE: If the Stand Up Lift is in the full UP position, it may be necessary to pull down slightly on the lift arms before the mast will lower.

EMERGENCY STOP. Press the RED button on the control box IN to stop the lift arms and patient from raising or lowering.

NOTE: Rotate RED emergency stop button CLOCK- WISE until it pops out to disengage.

UP Button

DOWN Button

 

 

Hand Control

 

Red Emergency Stop Button

Control

Box

Press IN to Stop

Rotate CLOCKWISE to

Lift Arms

Disengage Emergency Stop

FIGURE 3 - RAISING/LOWERING

STAND UP LIFT

MOUNTING BATTERY CHARGER (FIGURE 4)

NOTE: Refer to your local regulations concerning proper mounting procedures.

1.Place the battery charger with mounting bracket on the wall at the desired position.

2.With a pencil, mark the MIDDLE hole position.

3.Measure down 16.5 cm from the pencil mark and drill one (1) mounting hole.

4.Install the BOTTOM mounting screw until there is an approximate 3 mm gap between the screw head and the wall.

5.Install the battery charger with mounting bracket onto the bottom mounting screw.

6.Drill the remaining two (2) mounting holes.

7.Install the two (2) remaining mounting screws through the mounting bracket and into the wall. Tighten securely.

8.Plug battery charger into the wall electrical outlet. NOTE: ON LED should illuminate.

Mounting Bracket

Battery Charger with Mounting

(STEP 6)

 

Bracket (STEP 5)

 

 

 

 

 

 

BOTTOM

Mounting

Mounting

 

Screw

Screws

(STEP 4)

(STEP 7)

 

 

 

 

 

 

 

 

 

 

 

FIGURE 4 - MOUNTING BATTERY CHARGER

CHARGING BATTERIES (FIGURE 5)

NOTE: Invacare recommends the battery be recharged daily.

NOTE: An audible alarm will sound (horn will beep) when battery is low.

1.Lift UP on the handle on the top of the battery.

2.Lift the battery UP and OUT away from control box.

WARNING

Make sure there is an audible click when mounting battery on the battery charger to confirm proper mounting. Otherwise, injury or damage may occur. Refer to FIG- URE 5 for correct mounting.

3.Place the battery on the battery charger as shown in FIGURE 5. Make sure there is an audible click.

NOTE: The charge LED will illuminate.When charging is complete, the charge LED will stop illuminating.

8

Image 8
Contents Stand UP Lift Model RPS350-1E Symbol Legend MaintenanceSpecial Notes Radio Frequency InterferenceTable of Contents Safety Summary Safety Summary Weight LimitationSpecifications AssemblyAttaching Mast to Base Figure Attaching Electric Actuator to Mast FigureOperation Operating the Stand UP LiftClosing/Opening Legs of Base Figure Locking/Unlocking the Rear Swivel Casters FigureRaising/Lowering Stand Up Lift Figure Mounting Battery Charger FigureCharging Batteries Figure Lifting Preparation StepsMake sure of the following Transferring fromLifting the Patient Figure Moving the Patient Figure StepMove the wheelchair into position Transferring toTransferring the Patient to a Wheelchair Figure Transferring the Patient to a BED Figure Steps 1Transferring the Patient to a Commode Figure Step Steps 4Maintenance Safety Inspection Checklist Troubleshooting Care and Maintenance of Your Stand UP Lift CleaningAdjusting the Base Figure Lubrication FigureReplacing the Knee PAD Figure Replacing the Padded Cover FigureReplacing Optional LEG Strap Figure Replacing Electric Actuator FigureReplacing Casters AND/OR Forks Figure Rear CasterFront Casters ForksLimited Warranty Page Symbolerklärung SonderhinweiseHochfrequenzstörungen WartungInhalt InhaltSicherheitsvorkehrungen WarnhinweisSicherheitsvorkehrungen Fortsetzung ErdungTechnische Daten ZusammenbauSO Befestigt MAN DEN Mast AM Untergestell AbbildungBetrieb Betrieb DES StandliftsSchließen/Öffnen der Beine des Gestells Abbildung Abbildung 2 SO Befestigt MAN DAS Bedienelement AM MastAufladen DER Batterien Abbildung Montage DES Ladegeräts AbbildungHeben/Senken der Liftarme Abbildung Abbildung 3 HEBEN/SENKEN DER LiftarmeAbbildung 5 Aufladen DER Batterien Vorbereitungen ZUM Anheben DES PatientenSchritt Verlagerung VOM Ruheplatz Anheben DES Patienten AbbildungBeförderung DES Patienten Abbildung Beförderung DES Patienten Schritt 1A Schritt 1BZUM Ruheplatz Abbildung 1 Anheben DES PatientenVerlagerung ZUM Ruheplatz Verlagerung DES Patienten in Einen Rollstuhl AbbildungBringen Sie den Rollstuhl in die gewünschte Posi- tion BetriebAbbildung 2 -VERLAGERUNG DES Patienten EIN Bett Verlagerung DES Patienten in EIN Bett AbbildungSchritt 1 UND Abbildung 3 Verlagerung DES Patienten AUF Einen Nachtstuhl Verlagerung DES Patienten AUF Einen Nachtstuhl AbbildungSchritt Schritt 4 UND Checkliste FÜR Inspektionen DES Wartungszustands Fehlerbehebung Pflege UND Wartung DESStandlifts Pflege UND Wartung DES LiftsPflege UND Wartung DES Standlifts Schmieren AbbildungReinigung Abnutzungserscheinungen UND SchädenAustauschen DER Polsterung Abbildung Austauschen DES Kniepolsters AbbildungAustauschen DES Optionalen Beingurts Abbildung Abbildung 5 Austauschen DER PolsterungAustauschen DER Räder UND/ Oder Gabeln Abbildung HinterradVorderräder GabelnHinweis ZUR Garantie Page Onderhoud Verklaring VAN DE Gebruikte SymbolenBijzondere Opmerkingen Inhoudsopgave InhoudsopgaveSamenvatting Veiligheidsinstructies WaarschuwingSamenvatting VEILIGHEIDSINSTRUCTIES, Vervolg GewichtsbeperkingenSpecificaties MontageMast AAN Onderstel Bevestigen Afbeelding Electrische Drijfstang AAN Mast Bevestigen AfbeeldingBediening HET Bedienen VAN DE StaliftIn-/uitklappen Van De Poten Figuur Afbeelding 2 Drijfstang AAN Mast BevestigenAcculader Ophangen Figuur Accu Opladen FiguurOmhoog/Omlaag Bewegen Van De Stalift Figuur DE StaliftFiguur 5 Accu Opladen Voorbereidingen Voor HET TillenStappen Overbrengen VAN HET Tillen VAN DE Patiënt FiguurFiguur 1 DE Patiënt Tillen DE Patiënt OverbrengenFiguur Overbrengen Naar DE Patiënt Overbrengen Naar EEN Rolstoel FiguurBreng de rolstoel in de juiste positie Figuur 1 DE Patiënt Overbrengen Naar EEN RolstoelDE Patiënt Overbrengen Naar EEN BED Figuur Breng de patiënt zover mogelijk over het bedDruk op de Neer Ð knop en laat de patiënt op het bed zakken Stappen 1 ENFiguur 3 DE Patiënt Overbrengen Naar EEN Postoel DE Patiënt Overbrengen Naar EEN Postoel FiguurStap Stappen 4 EN Controlelijst Voor Onderhoud EN Veiligheidsinspectie Probleemoplossing AccuVerzorging EN Onderhoud VAN UW Stalift SMERENFIGUUR1Slijtage EN Beschadigingen SchoonmakenKniesteun Vervangen Figuur Optionele Beenriemen Vervangen FiguurGecapitonneerde Bekleding Vervangen Figuur Elektrischaangedrevendeel Vervangen FiguurZwenkwielen EN/OF Vorken Vervangen Figuur Achterste zwenkwielVoorste zwenkwieltjes VorkenGarantiebeperkingen Page Entretien Garantie Table DES MatieresMontage Regles DE Securite Regles DE Securite Suite Instructions Relatives À LA Prise DE TerreSpecifications Techniques Fixation DU MAT a LA Base SchemaFixation DE L’ACTIONNEUR Electrique AU MAT Schema Schema 1 Fixation DU MAT a LA BaseFermeture/Ouverture Axes de la Base Schema FonctionnementSchema 4 Installation DU Chargeur DE Batterie Installation DU Chargeur DE Batterie SchemaCharge DES Batteries Schema Etape Schema 5 Charge DES BatteriesPreparation DU Transfert Levage DU Patient Schema Premiere Etape DU TransfertDeplacement DU Patient Schema Schema 1 Levage DU Patient Schema 2 Deplacement DU PatientTransfert DU Patient a UN Fauteuil Roulant Schema Schema 1 Transfert DU Patient a UN Fauteuil RoulantSeconde Etape DU Transfert Placez le fauteuil roulant dans la positionappropriéeEtapes 1 ET Transfert DU Patient a UN LIT SchemaSchema 2 Transfert DU Patient a UN LIT Transfert DU Patient a UNE Chaise Percee Schema Schema 3 Transfert DU Patient a UNE Chaise PerceePositionnez le patient au dessus de la chaise percée Harnais de Transport Modèle R134Harnais Lesroulettesdelabase’AXECENTRAL Batterie Resolution DES IncidentsCharge DE LA Graissage Schema Reajustement DE LA Base SchemaUsure ET Deterioration NettoyageRemplacement DU Protege Genoux SchemaRemplacement DE LA Gaine DE Protectrice Schema Remplacement DE L’ACTIONNEUR Electrique SchemaRemplacement DES Roulettes ET/OU DES Fourches Schema Roues arrièreRoulettes avant FourchesGarantie Limitee Page Notas DE Atención Lectura DE LOS SímbolosInterferencias DE Radio Frecuencias MantenimientoÍndice Lista DE Comprobación Para LA Inspección DE Seguridad ENResumen DE Puntos DE Seguridad AvisoResumen DE Puntos DE Seguridad Continuación Instrucciones BaseEspecificaciones ArmadoColocación DEL Poste EN LA Base FiguraOperación Manejo DEL Elevador VerticalCerrado / Apertura Patas de la Base Figura Pise Aquí Para Pise Aquí ParaMontaje DEL Cargador DE Baterías Figura Cargado DE Baterías FiguraElevación / Descenso del Elevador Vertical Figura Con un lapicero marque la posición MediaPreparación Para EL USO DEL Elevador Figura Cargado DE BateríasTransferencia Desde Levantar AL Paciente FiguraSolicite al paciente que realice lo siguiente Asegúrese de lo siguientePaso Mover AL Paciente FiguraPaso 1A Paso 1B Transferencia a Transferir AL Paciente a UNA Silla DE Ruedas FiguraColocar la silla de ruedas en la posición adecuada PasoTransferir EL Paciente a UNA Cama Figura Colocar al paciente todo lo dentro de la cama que se puedaTransferir AL Paciente a UNA Silla Retrete Figura Paso Pasos 4 YLA Base DE LAS Ruedas PalancaelevadoraMástil Brazos DEL Elevador Y JuntasSolución DE Problemas AtenciónAtención Y Mantenimiento DEL Elevador Vertical Lubricación FiguraDesgaste Y Daños LimpiezaSustitución DEL Apoyo Para LAS Rodillas FiguraSustitución DE LA Correa Opcional Para LAS Piernas Figura Sustitución DE LA Funda FiguraSustitución DE LAS Ruedas Giratorias Y/O Horquillas Figura Ruedas Giratoria PosteriorRuedas Giratorias Frontales HorquillasGarantía Limitada

RPS350-1E specifications

The Invacare RPS350-1E is a cutting-edge power wheelchair designed to enhance mobility for individuals with disabilities or limited physical abilities. This model is specifically crafted to provide exceptional comfort, stability, and versatility in various environments, whether indoors or outdoors.

One of the standout features of the RPS350-1E is its robust and resilient construction. Built on a strong, durable chassis, the wheelchair is capable of supporting users with a weight capacity of up to 350 pounds. This ensures that individuals of varying sizes can benefit from its advanced design without compromising safety. The RPS350-1E also includes a spacious footplate, which allows for comfortable leg positioning during extended use.

The wheelchair is equipped with advanced seating technology, including a contoured seat cushion that promotes optimal pressure relief and comfort. The adjustable backrest allows users to find their perfect angle for relaxation or support, catering to individual preferences. Additionally, the seat height can be customized to accommodate different user needs, enhancing accessibility and comfort.

Power and performance are paramount in the RPS350-1E, which is powered by high-efficiency brushless motors. These motors not only provide impressive torque but also ensure a smooth and quiet ride, allowing users to navigate various terrains with ease. The wheelchair is integrated with a powerful lithium-ion battery, providing extended driving range and reduced charging time, making it ideal for daily use.

The smart joystick controller offers users precise control over the wheelchair's movements. With programmable settings, users can easily adjust the speed and sensitivity of the joystick to suit their individual needs. Moreover, the RPS350-1E is equipped with advanced safety features such as automatic braking, anti-tip technology, and a robust suspension system, ensuring safe operation on inclines and rough surfaces.

In conclusion, the Invacare RPS350-1E stands out in the power wheelchair market due to its combination of durability, comfort, and advanced technology. Its thoughtful design and user-friendly features make it an excellent choice for individuals seeking a reliable mobility solution that empowers them to achieve greater independence in their daily lives. With its impressive capabilities, the RPS350-1E ensures users can confidently navigate their environment while enjoying unparalleled comfort and support.