Invacare 9000XT Recliner, 9000 XT, 9000 XDT Stability Recliner Models only, Operating Information

Page 11

GENERAL GUIDELINES

SECTION 1

WARNING (CONTINUED)

ANTI-TIPPERS (CONTINUED)

Seat-to-floor angle of 6°: If changing the seat-to-floor angle to 6° , anti-tippers MUST be installed.

STABILITY - RECLINER MODELS ONLY

WARNING

Anti-tippers MUST be installed. DO NOT operate without anti-tippers. ALWAYS make sure that the wheelchair is stable BEFORE using the recliner option. Ensure the spreader bar is attached and secured before using the 9000XT Recliner. Always return the back to the upright position before lifting the wheelchair.

LIFT KIT MODELS ONLY - Both spring lift mechanisms MUST be operational BEFORE using the recliner. DO NOT operate the recliner option if only one (1) of the spring lift mechanisms is operational.

LIFT KIT MODELS ONLY - DO NOT attempt to recline or incline the wheelchair back without occupant. Back will raise ABRUPTLY and cause injury. Keep clear when reclining or inclining chair back to avoid injury.

OPERATING INFORMATION

WARNING

Unless otherwise noted, all service and adjustment should be performed while the wheelchair is unoccupied.

To determine and establish your particular safety limits, practice bending, reach- ing and transferring activities in several combinations in the presence of a quali- fied healthcare professional BEFORE attempting active use of the wheelchair.

ALWAYS wear your Seat Positioning Strap. Inasmuch as the SEAT POSITION- ING STRAP is an option on this wheelchair (You may order with or without the Seat Positioning Strap), Invacare strongly recommends ordering the Seat Posi- tioning Strap as an additional safeguard for the wheelchair user.

Always verify that hand grips on the rear cane are secure PRIOR to use when an assistant is used to propel or lift the chair. Check for any signs of looseness or deterioration and if found, contact a qualified technician. DO NOT attempt to move the wheelchair by using the hand grips if they are found to be unsecure or have deteriorated.

When cleaning rear cane or hand grip areas use only a clean towel lightly damp- ened with cool water. Verify that grips are dry prior to use. Use of soap or am- monia based cleaning solutions will result in the hand grips sliding off the cane assembly. Failure to observe this warning may result in injury to the user or bystanders.

DO NOT sit or transfer into the wheelchair unless it is fully open and the seat frame rails are fully seated into the side frame H-blocks.

GENERAL GUIDELINES

Part No. 1056953

11

9000 Series

Image 11
Contents Series Series Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesXT Recliner Models only LocationslabelLabel Locations XDT onlySpecifications Specifications9000 XDT XT ReclinerGeneral Guidelines Information for Healthcare PROFESSIONALS/ AssistantsGeneral Guidelines Section Section General Guidelines Stability ALL ModelsANTI-TIPPERS Operating Information Stability Recliner Models onlyGeneral Guidelines Tire Pressure Weight TrainingWeight Limitation Coping with Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance Percentage of Weight Distribution Tipping REACHING, Leaning and Bending ForwardREACHING, Leaning Backwards Tipping Curbs Method 1 Wheelchair With Step Tubes ESCALATORS? Sorry StairwaysUnfolding and Folding the Wheelchair Transferring to and from Other SeatsSOLID-SEAT Models Hammock or Sling Seat ModelsSafety Inspection Safety Inspection ChecklistSafety Inspection Section Suggested Maintenance Procedures TroubleshootingMaintenance Maintenance Safety PrecautionsSafety Inspection Front Riggings INSTALLING/REMOVING/USING the FOOTREST/LEGREST FigureUsing RemovingFront Riggings Section Footrest Height Adjustment FigureImpact GUARDS/CALF Strap Figure Replacement Heel Loop Replacement FigureAdjusting the Elevating Legrest Assembly RAISING/LOWERING the Elevating Legrest Assembly FigureSection Arms Adjusting Armrest Height FigureSWING-BACK Arms Figure ArmsRemoving Armrests Removing or Replacing Armrest FigureArmrest PAD Clothing GuardSpace Saver ARM Position Conventional ARM Position Seat and Back Replacing the Seat Upholstery FigureSeat and Back Section Section Seat and Back Replacing the Back UpholsteryScrew on Back Upholstery 9000 SL Figure Slip on Back Upholstery 9000 XT/XDT FigureAdjusting the Seat Width Adjusting the Back HEIGHT, Back Angle or Seat DepthWheelsrear REMOVING/INSTALLING the Rear WheelsPermanent Axles QUICK-RELEASE Axles FigureInside Wheelchair Outside Detail a Locking Pins and Detent PINRear Wheels Section Rear WheelsReplacing Rear Wheel Handrim Figure REPLACING/REPAIRING Rear Wheel TIRE/TUBEAdjusting the QUICK-RELEASE Axle Adjusting the QUICK-RELEASE Axle FigureSection Front Casters CastersfrontFront Casters Section REPLACING/REPAIRING Front Caster TIRE/TUBEFront Caster Mounting Adjustments Section ANTI-TIPPERS/WHEEL Locks INSTALLING/ADJUSTING the ANTI-TIPPERSInstalling ANTI-TIPPERS Figure Anti LOCKSTIPPERS/WHEELANTI-TIPPERS/WHEEL Locks Adjusting FigureANTI-TIPPERS/WHEEL Locks Section Wheel Locks are not Brakes USING/ADJUSTING the Patient Operated Wheel LocksUsing the Patient Operated Wheel Locks Figure Adjusting the Patient Operated Wheel Locks FigureBOLT-ON Wheel Locks CLAMP-ON Wheel Locks To Healthcare PROFESSIONALS/ASSISTANTS Recliner Operation FigureRecliner Section ReclinerReclined Position Recliner SectionUpright Position Back Upholstery Replacing the Headrest Pillow FigureReplacing the HEADREST/BACK Upholstery Figure Headrest UpholsteryAdjusting the Seat Depth Adjusting HEADREST/BACK Upholstery Tension FigureRear View of 9000XT Recliner STORING/REPLACING the Spreader BARStoring Figure Replacing FigureLENGTH, Height KIT Number Installing the ANTI-TIPPERS FigureWith Attendant Operated Wheel Locks Figure With Patient Operated Wheel Locks FigureAdjusting Attendant Operated Wheel Locks Figure USING/ADJUSTING the Wheel LocksUsing Attendant Operated Wheel Locks Figure Step Installing the Telescoping I.V. RODInstalling the Telescoping I.V. ROD Holder Figure Adjusting the Telescoping I.V. ROD Figure Installing the Telescoping I.V. ROD Support Tube FigureSection Options InstallingOptions Options Section Installing the Solid Folding Seat FigureInstalling the Crutch and Cane Carrier Figure CleaningInstalling the Amputee Bracket Super Hemi Models only Figure Rear View Amputee Bracket Installing the Amputee Bracket ALL Models Except Super HemiBracket a Bracket B Bracket a Installing the Amputee Bracket 9000XDTWarranty WarrantyCanada
Related manuals
Manual 30 pages 6.48 Kb Manual 88 pages 25.16 Kb