FRONT RIGGINGS
SECTION 3 | FRONT RIGGINGS |
|
|
Section 3 - Front Riggings includes the following:
Installing/Removing/Using the Footrest/Legrest
Footrest Height Adjustment
Impact Guards/Calf Strap
Heel Loop Replacement
Raising/Lowering the Elevating Legrest Assembly
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.
INSTALLING/REMOVING/USING THE FOOTREST/LEGREST (FIGURE 1)
Footrest Release Lever
NOTE: This procedure applies to the swingaway |
| Swingaway | |
footrest and elevating legrest. |
| ||
| Footrest | ||
| Hinge | ||
INSTALLING | Assembly | ||
Pins | |||
| |||
1. Turn the swingaway footrest assembly |
| Footplate | |
| Hinge | ||
to the side (open footplate is perpen- |
| ||
| Plates | ||
dicular to wheelchair). |
| ||
|
| ||
2. Install the hinge plates on the swing- | FIGURE 1 - INSTALLING/REMOVING/ | ||
away footrest assembly onto the hinge | |||
pins on the wheelchair frame. | USING THE FOOTREST/LEGREST | ||
3.Push the swingaway footrest assembly towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat this procedure for the other footrest assembly.
REMOVING
1.Push the footrest release lever inward.
2.Rotate swingaway footrest assembly outward.
3.Lift the swingaway footrest assembly off of the hinge pins.
USING
1.To move the footrest out of the way without removing, push the footrest release lever inward, rotate footrest outward.
2.To lock the footrest, push the swingaway footrest assembly towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
9000 Series | 24 | Part No. 1056953 |