SECTION 10 | OPTIONS | |
|
|
|
1.Slide the clamp with the base attached over the end of the step tube of the wheelchair. Ensure the base is towards the inside of the
wheelchair.
OPTIONS
2. Position the base parallel to the step tube.
CAUTION
Base should be parallel to step tube to avoid bending spokes when folding the wheelchair.
3.Securely tighten the locknut that secures the base to the step tube of the wheelchair.
4.Remove the upper back upholstery screw and washer.
5.Align the strap with the back upholstery screw mounting hole.
Strap
Base
Step
TubeClamp
Locknut
FIGURE 3 - INSTALLING THE CRUTCH AND CANE CARRIER
6.Reinstall the back upholstery screw and washer and secure the strap to the wheelchair.
7.The base cleans easily with any chrome or glass cleaner. The strap can be cleaned with mild soap and water.
INSTALLING THE AMPUTEE BRACKET - SUPER HEMI MODELS ONLY (FIGURE 4)
1.Remove the plug button or
2.Slide the amputee attachment over the step tube of the wheelchair.
3.Secure the amputee attachment to the wheelchair with the hew screw, spacer and locknut.
4.Reinstall the plug button or
5.Repeat STEPS
6.Reposition the rear wheels. Refer to
REMOVING/INSTALLING REAR WHEELS in SECTION 6 of this manual.
| Wheelchair |
Spacer | Frame |
| Locknut |
Step
Tube
Hex Screw
Amputee Attachment
FIGURE 4 - INSTALLING THE AMPUTEE BRACKET - SUPER HEMI MODELS ONLY
9000 Series | 56 | Part No. 1056953 |