Invacare 9000 XDT, 9000 XT, 9000XT Recliner, 9000 Series BOLT-ON Wheel Locks CLAMP-ON Wheel Locks

ANTI-TIPPERS/WHEEL LOCKS SECTION 8

4.Securely tighten the bolt and locknut or socket screws securing the wheel lock to the wheelchair frame.

5.Engage the wheel lock.

6.Measure the distance the wheel lock is embedded into the tire as shown in DETAIL "A" of FIGURE 4.

NOTE: Any wheel lock adjustment should embed the wheel lock shoe at least 1/8-inch (3/16-inch if pneumatic tire) into the tire when engaged.

7.Repeat STEPS 1-6 until the wheel lock shoe embeds the tire 1/8-inch (3/16-inch for pneumatic tires) and HOLDS the occupied wheelchair in place when pushed.

8.Repeat STEPS 1-7 for the opposite wheel lock.

9.If the measurement of 1/8-inch (3/16-inch for pneumatic tires) can not be achieved, Perform one (1) of the following:

A.BOLT-ON WHEEL LOCKS - Remove the bolt and locknut that secure the wheel lock to the wheelchair frame and mount the wheel lock in one (1) of two

(2) mounting positions.

B.CLAMP-ON WHEEL LOCKS - Loosen the two (2) set screws on the wheel lock clamp and adjust the wheel lock position in the clamp.

10.Repeat STEPS 1-9 until the wheel lock HOLDS the occupied wheelchair in place when pushed. If the correct measurement still cannot be achieved, contact a quali- fied technician.

	BOLT-ON WHEEL LOCKS		CLAMP-ON WHEEL LOCKS
Mounting Positions		Bolt and Locknut	Socket Screws	Wheel Lock
				Clamp
		Wheel Lock
				Wheelchair
Wheel		Handle	Wheel Lock
		Wheel Lock		Frame
Lock
		Shoe
		Rear
		Wheel
DETAIL "A" - WHEEL LOCK SHOE
	ENGAGEMENT
		1/8-inch (3/16-inch
		pneumatic tires)
		Wheel Lock	Wheel Lock
		Shoe	Shoe

Tire Rear Wheel

FIGURE 4 - ADJUSTING THE PATIENT OPERATED WHEEL LOCKS

ANTI-TIPPERS/WHEEL LOCKS

Part No. 1056953 43 9000 Series