Invacare 9000XT Recliner manual Locationslabel, Label Locations, XDT only, XT Recliner Models only

LOCATIONSLABEL

LABEL LOCATIONS

LABEL LOCATIONS

Crossmember

9000 XDT ONLY

Lower Frame

Tube

	NOTE: On all anti-tippers		WARNING
		Refer to Owner's Manual
	EXCEPT non-adjustable
		for proper anti-tipper
IMPORTANT NOTICE	anti-tippers.	setting.	1085379
The wheel locks on this wheelchair have been
pre-set at the factory to comply with the			WARNING
Veterans Administration functional Standard
8320.01 of the Federal Register, paragraph		DO NOT OPERATE WITHOUT
3.2.4.5.3. If these wheel locks do not meet		THE ANTI-TIP TUBES
your needs, follow instructions below.		REV. 5/98	INSTALLED. P/N 60106X144
! CAUTION	9000 XT RECLINER MODELS ONLY
Any wheel lock adjustments should embed
wheel lock shoe at least 1/8" into tire when	WARNING
locked (3/16" on pneumatic tires).

INSTRUCTIONS FOR WHEEL		DO NOT OPERATE WITHOUT
	LOCK ADJUSTMENTS		THE ANTI-TIP TUBES
		REV. 5/98	INSTALLED. P/N 60106X144
1.	Loosen wheel lock mounting fastener,
	which runs through mounting bracket and
	frame.
2.	Slide clamp toward rear wheel until wheel
	lock shoe is embedded into tire material at
	least 1/8" when handle is engaged to the
	lock position (3/16" for pneumatic tires).
3.	Tighten mounting fastener to secure
	mounting bracket in desired location and
	recheck lock shoe embedding.
4.	Inspect for correct locking action BEFORE
	actual use.
	00078X021-0394		CAUTION

DO NOT recline without occupant. When the
chair is not occupied the back will raise abrup-
tly. Keep clear of the chair back when raising
or lowering to avoid injury.	1023096

MODELS WITH
QUICK-RELEASE
AXLES ONLY		CAUTION
		SERVICE OF SPRING
WARNING		LIFT MECHANISM TO
		BE PERFORMED BY
DETENT BALLS MUST BE SECURE-
		PROPERLY TRAINED
LY SEATED IN RECESSED AREAS
OF AXLE BUSHINGS. ENSURE		AUTHORIZED SERVICE
THAT PLUNGER PIN IN HEAD END
		PERSONNEL ONLY.
OF AXLE IS FULLY RELEASED.
KEEP DETENT BALLS CLEAN.		1022642
1001948
9000 Series	6	Part No. 1056953